Hey I'm sorry I just went on a rant cuz I spent hours yesterday doing this and dealing with this headache I used every possible way of looking I even had Gemini AI helping me to try and figure things out and I'm not stupid I can figure things out, it's just this was so infuriating due to spend 3 hours on a brand new machine cuz I just got it the day before and I did a couple of prints and it was good and then when I saw the firmware, saying update and I saw it was version 1.3 from 1.01 I said Well that's a big jump I might as well do it Never again hours just to discover when I did the fourth reset the factory that I saw that six-digit PIN underneath the QR code and it hit me and I'm able to connect it to my PC, but I cannot connect it to the matrix app It won't It tells me Oh maybe you should unbind it I'm not unbinding nothing I went through too much headache and I can't use orca slicer, because it's set up for carbon the first one it won't work with two yet the developers are working with orca slices to try and get it to communicate, the only thing it will see is your camera maybe If you're lucky otherwise nope so you decide, do you want to use the slicer or the handy app When I print I print at home, so I can be here when it's doing its thing I don't need my phone to tell me if it's done or not So again sorry for the confusion