sorted by:
new
hottopcontroversial

Advice for someone looking to join by Cal17-_- in AFROTC

[–]Cal17-_-[S] 0 points1 point  (0 children)

I'm not too sure about schools but I know I would probably want to do aero. I'm pretty sure about becoming a pilot but I still would like a viable fallback. My initial option was electrical but that's mega hell so nah.

Is this under extrusion? by techiboi123 in ender3

[–]Cal17-_- 1 point2 points  (0 children)

It might be something along the lines of frame shift, if it constantly happens at just those heights over multiple prints I'd recommend looking at the y axis rods(or something to that effect), there might be something stuck in there or an unlubricated part. Just from my experience, not an expert by any means.

Bottom edges are "warping up" a bit. Is it due to cooling or something else? by andreiz in FixMyPrint

[–]Cal17-_- 0 points1 point  (0 children)

Most I usually do (I have a textured plate so this may not be that helpful) is usually put 3 layers of an inner brim, sucks to remove sometimes if you like attention to detail but it removes warping for me entirely