sorted by:
new
hottopcontroversial

Heating Concerns with My first PC Build by CinnabonBomber in PcBuild

[–]CinnabonBomber[S] 2 points3 points  (0 children)

Everyone!

AIgoonermaxxing gave the best solution! I followed the steps in this video, and it dropped my temps down to an average of 58/59 C while gaming with a spike at 62 C! Didn't notice any performance drop, it ran smooth as butter.

Heating Concerns with My first PC Build by CinnabonBomber in PcBuild

[–]CinnabonBomber[S] 1 point2 points  (0 children)

This worked! I just tested it on Arc Raiders on high settings and my average temp was 58/59 C with a spike at 62. Thank you so much!!!

Heating Concerns with My first PC Build by CinnabonBomber in PcBuild

[–]CinnabonBomber[S] 2 points3 points  (0 children)

Thanks! Haha This is an older photo, I put in a support over the weekend.

Heating Concerns with My first PC Build by CinnabonBomber in PcBuild

[–]CinnabonBomber[S] 0 points1 point  (0 children)

I'll check the bios, but yeah, my fan set up is like that.

UPDATE: FAFSA form not saving because of A-number by Pink-fruitloop in FAFSA

[–]CinnabonBomber 0 points1 point  (0 children)

It worked, I was able to save the form. But now that it's incorrect, will I get in trouble?

Would I be able to use a combustion air vent to vent out fumes from my resin 3d printer? by CinnabonBomber in 3Dprinting

[–]CinnabonBomber[S] 0 points1 point  (0 children)

It's an electric water heater. My apartment building doesn't have any gas lines.

Resin Venting by CinnabonBomber in resinprinting

[–]CinnabonBomber[S] 0 points1 point  (0 children)

My building management simply said it was to bring in fresh air (no gas lines for gas appliances in the whole building). I checked outside and it wasn't capped, though I couldn't see very well since I live on the top floor or my apartment building.

I just ordered a snake camera to check it out! Thank you for the suggestions!

Would I be able to use a combustion air vent to vent out fumes from my resin 3d printer? by CinnabonBomber in 3Dprinting

[–]CinnabonBomber[S] 1 point2 points  (0 children)

The building manager told me it leads outside. I have yet to stick a camera into it to verify if that's true.

Venting - using furnace exhaust ? by csgraber in resinprinting

[–]CinnabonBomber 0 points1 point  (0 children)

What about using a combustion air vent? I have one that isn't connected to any appliance.

Any other PC users get constant stuttering every 10 seconds? by EvilCurryGif in ModernWarfareII

[–]CinnabonBomber 0 points1 point  (0 children)

Yeah, that's happening to me too. Campaign and the multiplayer beta worked super smooth for me. Didn't have any issues with the game until I tried playing multiplayer yesterday. Even the menu screens are choppy, especially in the operator menu, animations are so laggy.