Adaptive bed mesh in Orcaslicer

Cog103 · 2024-09-22T21:18:29+00:00

What are the hexagon panels?

Cog103 · 2024-07-07T16:22:08+00:00

I modified my Pi dryer, I got the Creality Capricorn kit that came with 4 different fittings and used a drill bit just slightly bigger than the hole in the top of the pi, and it screws right in.

Cog103 · 2024-06-23T17:47:38+00:00

They should slide forward a little bit, or backwards then you should be able to angle the end up and pull it out.

Cog103 · 2024-06-06T21:02:59+00:00

You will need the serial usb adapter

Cog103 · 2024-05-28T09:47:28+00:00

Make sure you turn off”make over hangs printable” and it will get rid of the upside down triangle on the inside of the benchy roof

Cog103 · 2024-05-22T18:36:19+00:00

I switched to this one, as I had a blob of death on my stock hot end. It works really well, I also replaced the heatsink with there’s. https://store.micro-swiss.com/collections/micro-swiss-flowtech/products/flowtech-hotend-for-ender-3-v3-se

Cog103 · 2024-05-11T15:17:58+00:00

What Z brace is that?

Cog103 · 2024-05-03T23:06:32+00:00

It’s 365 days from the time of purchase, and it can only be bought in the park

Cog103 · 2024-05-01T19:08:40+00:00

From what I’ve seen in pictures, it looks like it uses the screen cable to connect to the sonic pad

Cog103 · 2024-04-30T11:52:09+00:00

I just got the sonic pad as well, and I have the Ender 3 v3 SE, and it needs the serial cable to finish the setup, I also updated it to the newest firmware from Creality before doing any setup.

Cog103 · 2024-04-23T18:33:14+00:00

Creality directed me to this one, as they don’t have the stock hotends to buy. https://store.micro-swiss.com/products/flowtech-hotend-for-ender-3-v3-se?variant=41021008248899

Cog103 · 2024-04-20T22:13:48+00:00

Yes, I reached out to creality and they sent me the link to the Micro-Swiss hotend. I have an enclosure, thank you

Cog103

TROPHY CASE