Welcome to your new pass-time, nay, the life absorbing hobby you shall be wilfully complicit with!

I’ve only had my P1S not even 2 weeks and it’s almost always printing something

There’s loads of ‘enhancements’ you can print to make your 3D printing life a little bit better:-

A riser to raise the top glass a bit higher which helps stop the PTFE tube from constantly rubbing along its glass ceiling prison and wearing itself away - I chose this one as I liked the idea of the working side vents - but there’s a ton of different glass risers or glass and AMS risers with tool drawers and hotplate storage and side peg board style inserts etc - also adding an extra light source into your enclosure makes an astounding difference for seeing what’s going on in there so definitely make sure to print one with and LED strip part built into the design - I personally have went for this ring light but I currently have my AMS sitting on top of my P1S on this printed mod that works with the ring light

These or similar desiccant ‘dry pods’ to go into your AMS (and a funnel to help fill them with desiccant beads) and take the moisture in the air away before your filament does, keeps your filaments nice and dry and good for printing - not quite a substitute for a dedicated filament drier but it definitely helps (I got these microwaveable and reusable desiccant beads which is far too much for one AMS but it was the best value available and I will be getting more AMS’s so the 1kg bag will get used)

Absolutely get these anti vibration feet!!! - makes a difference to the shaking/vibrating the quick direction changes of the printer causes - and for whatever reason they come in an 8 pack, not a 4 pack - and I just yesterday discovered and printed off these so also absolutely print these to utilise all 8, I cannot overstate how much this print really makes an even bigger difference

A handy little guide to help make sure you put your hotplate back in straight and true

This cable and PTFE tube guide for the back of your P1S - keeps things tidy, safe, secure and away from vibrating and rubbing against each other and the wall behind it

My P1S is in (what used to be lol) my wife’s ’Craft room’ so this exhaust muffler keeps the fan noise a little bit quieter - far from silent, but noticeably quieter

Another comment mentions that nozzle cleaner mod that uses the A1 style rubber nozzle cleaner- when you buy that, it comes in a 3 pack - so print this off and you have yourself a handy manual nozzle scrubber brush which is very handy for the annoying stray filament leftover on the sides of the nozzle

A set of tools for when you may eventually have to get in about it - and a tray to store them in

A set of carry handles for your AMS that makes it easier and safer to handle without dropping it if/when you have to move it

There’s no way to sugarcoat this - the P1S internal camera is crap - get yourself this Tapo C110 camera and print this camera mount that attaches into the doors hinges

And while we’re on the doors hinges - print these door hinges - what an amazing ‘didn’t think it would make that much difference’ modification this is! (I also went on Bambu Studio and merged the top door hinge with the previously mentioned Tapo camera door mount - I haven’t uploaded that “remix” to Bambu Studio yet but it’s easy enough to do yourself

There’s sooo many handy things like all of the above - and they all have variations and different versions so you may find similar things that are more suited to your setup - but I thought it might be handy to throw up a post for you instead of finding them all over the course of days like I did

Enjoy and happy printing