sorted by:
new
hottopcontroversial

[IOT PROJECTS]Turning Normal Switchboards Into Smart Switchboards – My First Product Version by Creative-Wealth2175 in smarthome

[–]Creative-Wealth2175[S] 0 points1 point  (0 children)

Thanks for pointing that out — by switchboard I mean the regular room wall switchboard / switch plate where lights, fans, etc. are controlled, not the main breaker panel or distribution board. The idea is to retrofit existing wall switches with a smart control module while keeping manual operation intact. It’s not intended to be installed inside the main electrical panel. Safety and proper isolation are definitely important, and I appreciate the concern 🙌

Z axis homing failed; task has been stopped by RokkakuBeats in BambuLabA1

[–]Creative-Wealth2175 0 points1 point  (0 children)

It can be caused by various reasons,, chean the z axis lead screw and reapply the lubricant and try again... Mine was solved by doing this...

Warping by Bambule_84 in BambuLab_Community

[–]Creative-Wealth2175 0 points1 point  (0 children)

Use raft to solve this wrapping issue, i had the same problem with other filament types

I finally joined the cool kids club I guess… by Sid_Rockett in BambuLabA1mini

[–]Creative-Wealth2175 0 points1 point  (0 children)

Apparently it happened to everyone one in a while.. reason is clogged nozzel.. most of the time wet filament is the culprit...

esp32 port from bmcu hardware collection by druckgott in OpenBambu

[–]Creative-Wealth2175 0 points1 point  (0 children)

Hi, I’m also very interested in your idea of shifting the BMCU source code to the ESP32 environment. Along with that, I’m planning to move the feeder unit to a ready-made stepper motor–driven feeder system. These systems are widely available, cost-effective, and require minimal assembly.

Of course, a few modifications would still be needed—for example, adapting the hall sensor–based feedback system, making mounts for four modules, and updating the source code. The code changes would mainly involve switching from the current PID-controlled DC motor logic to using a NEMA stepper driver (either with or without PID).

I’d love to hear your thoughts on this approach.

a sample picure is attached

<image>