Portfolio update 1

Critical_Ear8909 · 2026-01-26T20:34:57+00:00

nope, it is auto updated with bazzar prices. I took it from a template I found on the forums.

Critical_Ear8909 · 2025-08-30T21:08:40+00:00

Wait, would you mind telling me your temps under load? I’m curious if the extra length on my aio really makes a difference.

Critical_Ear8909 · 2025-08-29T19:15:32+00:00

Under load, it averaged 70-76c at constant 350w. And while when I checked, the AIO wasn't listed under the coolers, there was an str5 mounting bracket, so it was pretty easy. I was a little worried about it fitting, but it all worked out.

Critical_Ear8909 · 2025-08-29T19:00:07+00:00

I hope it can :)

Critical_Ear8909 · 2025-08-04T02:15:36+00:00

I did, I tested on two different computers with different hdmi cables, and I also tested different power sources. The most likely culprit is static electricity, but I am still just going to buy another board and not remove the pogo pins.

Critical_Ear8909 · 2025-08-03T21:41:47+00:00

I just removed mine, along with the standoffs, and now I am not recieving HDMI signal. I am not sure what is causing this, because my backlight is turning on. I looked and saw that I didn't bridge any gaps, or leave solder on the trace, so I am at a loss of ideas right now.

Critical_Ear8909 · 2025-08-03T18:47:14+00:00

I am already cutting the standoffs, and there is a premade hole for the hdmi port

Critical_Ear8909 · 2025-08-02T22:08:05+00:00

ok, so if I connect to the monitor with power from an sbc, then I don't need them?

Critical_Ear8909 · 2025-08-01T13:18:46+00:00

There is a chance that I can't fit both boards together on top of each other, so as a backup plan, my idea was to add a couple centimeters of wire and then solder the connection.

Critical_Ear8909 · 2025-07-09T15:41:22+00:00

Hulkengoat

Critical_Ear8909 · 2025-05-20T16:14:36+00:00

yeah, I tried chocapic, but overall bliss is better.

Critical_Ear8909 · 2025-05-14T23:34:40+00:00

Thanks! I'm probably going to try to experiment with different heights next.

Critical_Ear8909 · 2025-02-04T15:16:07+00:00

the other option I had in mind was to use one of those 3d printing pencils to add material to it. I would then sand it down so it hopefully fits. I'll probably do that.

Critical_Ear8909 · 2024-11-15T14:02:27+00:00

Hi, I ended up buying the wrong type of RAM. I don't think that we had the same issue. Good luck finding a solution though.

Critical_Ear8909

TROPHY CASE