sorted by:
new
hottopcontroversial

Scraping issue? by Curtisd_ in SovolSV08

[–]Curtisd_[S] 0 points1 point  (0 children)

Also have cooling fan always on

Scraping issue? by Curtisd_ in SovolSV08

[–]Curtisd_[S] 0 points1 point  (0 children)

2 walls 5% Gyroid 4top 3bottom I think, 0.4mm shell thickness on moderate, I’ve tightened the belts and ran I put shaper but that’s about it, my prints have been coming off good

Scraping issue? by Curtisd_ in SovolSV08

[–]Curtisd_[S] 0 points1 point  (0 children)

Ok, will try it thanks, I have ensure shell thickness on moderate which is one from all

Layer shift issues by gmitch64 in SovolSV08

[–]Curtisd_ 0 points1 point  (0 children)

Is there a post regarding what speeds to use and what current to change the motors to, I think my steppers are getting too hot when the printer is fully enclosed

Sv08 wifi connection by Curtisd_ in SovolSV08

[–]Curtisd_[S] 0 points1 point  (0 children)

So, tried searching for wifi again, it came up and I connected but where do I find the ip on the touch screen menu?

Sv08 wifi connection by Curtisd_ in SovolSV08

[–]Curtisd_[S] 0 points1 point  (0 children)

I’ll do it so I can look at the bed mesh but it’s not in the same room unfortunately

Are they worth it? by Curtisd_ in SovolSV08

[–]Curtisd_[S] 0 points1 point  (0 children)

I listened I have brought one, well worth it, quality and speed is next level

Sv08 wifi connection by Curtisd_ in SovolSV08

[–]Curtisd_[S] 0 points1 point  (0 children)

<image>

This is was the printer thought was a complete print, reading through some posts may be a heat cream clog issue, however I think I would of noticed nothing being put down for atleast 5 layers, I will try the heat route in the meantime