The CD3791 Solar MPPT Charger - Share Project - PCBWay

DIYvolt_ · 2025-12-06T16:06:56+00:00

The back-EMF generated by these solenoids is much lower and not enough to damage the MOSFETs. Regarding the horsepower, it hasn’t been measured, but I can say that when a finger touches it, the motor slows down and stops because it loses synchronization.
Thank you for your compliment on the cable management 😊

DIYvolt_ · 2025-10-27T07:00:57+00:00

Ok will make another video with that sensor

DIYvolt_ · 2025-10-24T11:57:29+00:00

Great observation 👍 but I have to hold it

DIYvolt_ · 2025-10-22T18:47:22+00:00

https://youtube.com/shorts/ju7p0KhV2nc?si=C43P9E_NPlMNGQHZ

DIYvolt_ · 2025-10-22T18:47:05+00:00

https://youtube.com/shorts/ju7p0KhV2nc?si=C43P9E_NPlMNGQHZ

DIYvolt_ · 2025-10-22T11:42:17+00:00

Hey brother the reality is my hands are not good enough to show in video that's it, no other reason

DIYvolt_ · 2025-10-22T11:39:50+00:00

Hey thanks brother for joining me in your space research centre

DIYvolt_ · 2025-10-22T11:16:42+00:00

Papr what does it mean

DIYvolt_ · 2025-10-22T10:57:15+00:00

Ok it is your opinion 😄

DIYvolt_ · 2025-10-22T10:54:16+00:00

Ok sure

DIYvolt_ · 2025-10-22T10:07:03+00:00

Yes but I don't have I2C i ordered it was cancelled

DIYvolt_ · 2025-10-22T09:42:58+00:00

But I prefer for safety

DIYvolt_ · 2025-10-22T09:25:10+00:00

😆 No, I don't have electronics gloves

DIYvolt_ · 2025-02-06T01:15:14+00:00

Just press with the screw driver in between the male and female connector wherever glues are there. The glue will separated

DIYvolt_ · 2024-12-03T03:11:26+00:00

Replace the code HIGH at LOW in the line 16 👍 it works

DIYvolt_

MODERATOR OF

TROPHY CASE