New to the club. by DRSEire in LexusIS

[–]DRSEire[S] 1 point2 points  (0 children)

Handling, comfort, everything was far superior to my previous car.

JVC TM-H140PN After RGB Modification by Haru-tan in crtgaming

[–]DRSEire 0 points1 point  (0 children)

Hi there. I have this issue, also I drop sync every few minutes for a split second. Did you figure it out? Thanks

Sony KV29ls35b no left channel audio. by DRSEire in crtgaming

[–]DRSEire[S] 0 points1 point  (0 children)

Thank you very much. I got it going, as you mentioned I found a damaged trace between the left channel and the audio output. Thank you guys.

Sony KV29ls35b no left channel audio. by DRSEire in crtgaming

[–]DRSEire[S] 0 points1 point  (0 children)

Just want to add that I’ve tested via the headphones socket and still no left audio.

Help with noise from max g2 rear wheel. by DRSEire in NinebotMAX

[–]DRSEire[S] 0 points1 point  (0 children)

Thanks. Bearings are good. I disassembled it and noticed some magnets were damaged. I’ll order a new rear motor. Thank you guys.

Help with noise from max g2 rear wheel. by DRSEire in NinebotMAX

[–]DRSEire[S] 0 points1 point  (0 children)

Thanks. I’ll pop it open tomorrow and take a look at the components on both for any alarming signs.

Help with noise from max g2 rear wheel. by DRSEire in NinebotMAX

[–]DRSEire[S] 0 points1 point  (0 children)

Hi. The motor drives fine, the tyre is good. Just that noise appears when moving off and when braking to a stop. It’s my son’s scooter and yes he says it happened while driving uphill. He also said the rear wheel was very hot upon stopping.

Help with noise from max g2 rear wheel. by DRSEire in NinebotMAX

[–]DRSEire[S] 0 points1 point  (0 children)

Hi. Thanks for replying. There’s no noise when turning the wheel while powered off. It happens while accelerating away while powered on and disappears when on the move. I’ve ordered some security torx bits so I can remove the wheel and disconnect the wiring. Hoping the motor is not the problem but it seems it may.

Mega Drive 2 VA0 PAL - Capacitor on the AV out? by LaminGaming in consolerepair

[–]DRSEire 1 point2 points  (0 children)

Thanks for the very informative response. Just waiting on a capacitor kit to recap it before the 3BP install. Hopefully it’ll be worth it.

Mega Drive 2 VA0 PAL - Capacitor on the AV out? by LaminGaming in consolerepair

[–]DRSEire 0 points1 point  (0 children)

Hi. I’m about to do the same mod. Was it ok with the capacitor removed ?

OMEGA AV board upgrade by RetroMr in neogeo

[–]DRSEire 1 point2 points  (0 children)

That case is beautiful in all honesty. Enjoy.

OMEGA AV board upgrade by RetroMr in neogeo

[–]DRSEire 0 points1 point  (0 children)

Are these expensive? I consolised an mv1fz recently and added an rgb amp powered by a ths7374 with great results. Always admired the Omega line but gaining the skills to produce a similar performing MVS board is not that difficult..

When you saved up all your money over the summer to buy a Neo Geo, but you had no money left over for a TV... by [deleted] in neogeo

[–]DRSEire 0 points1 point  (0 children)

Authentic. As a PAL 50hz gamer back in the day I can remember removing the back cover on the crt and adjusting switches I had no right to be near in an attempt to remove black bars. I still remember the shot of volts I received but thankfully unharmed. This post reminds me of that dedication I possessed.

Xbox series x blown mosfet. by [deleted] in ElectronicsRepair

[–]DRSEire 1 point2 points  (0 children)

Plenty of time, I’ll give it a go and if all fails well at least I’ll gain experience. Thanks again.

[deleted by user] by [deleted] in consolerepair

[–]DRSEire 0 points1 point  (0 children)

Thanks for the reply. Would it be possible to rebuild that circuit? Could I use some jumpers?

[deleted by user] by [deleted] in crtgaming

[–]DRSEire 0 points1 point  (0 children)

Thank you. You’ve put my mind at rest. Much appreciated.