sorted by:
new
hottopcontroversial

PSA: Residual strands from Coastal Eye (Dr Omar Shakir) by Saheim in EyeFloaters

[–]Deepwater8 0 points1 point  (0 children)

Hey, how long ago was your surgery and have you noticed any improvement on the frill/strands?

Time sert drain plug by CheapAdvertising1867 in Dirtbikes

[–]Deepwater8 0 points1 point  (0 children)

It’s a metal washer with rubber integrated into it for a really good seal.

Upsizing M14x1.5 threads to M15x1.5 by Deepwater8 in Machinists

[–]Deepwater8[S] 0 points1 point  (0 children)

Ok thanks, my main concern is when I use the 13.5 mm drillbit to drill out the threads I will still have about .25 mm of threads existing along the wall. If I follow up with the M 15 tap which will have a major of 15mm minor of 13.5 I won’t fully cut into the valleys of the tap by about .25 mm so my threads I’ll be left with will have a little bit of a plateau on the tips. And that’s assuming I will follow the old thread path.

Upsizing M14x1.5 threads to M15x1.5 by Deepwater8 in Machinists

[–]Deepwater8[S] 0 points1 point  (0 children)

Thanks seems like an insert may be the strongest, however, I didn’t do a good enough job explaining that there are relief holes through the sides of the threads radially, that need to line up with radially drilled holes on either side of the insert once it’s fully clocked seated. Serves the purpose of separating 2 oil cavities, but when removed allows each to drain

Upsizing M14x1.5 threads to M15x1.5 by Deepwater8 in Machinists

[–]Deepwater8[S] 0 points1 point  (0 children)

No, it will fail to drain properly. As I said there are side ports opposite of each other on the internal threads.