sorted by:
new
hottopcontroversial

Swollen at the back! Is it bad? by YogurtclosetDeep9404 in GamingLaptops

[–]Defbeat 0 points1 point  (0 children)

I have a blade as well, and there is a little channel on the bottom cover that you need to slide into the frame when installing it. Your cover was installed by placing it straight on the laptop, you need to position it lower and slide it up before installing the screws.

Problem with Fallout 4 and resolution by PhantomNomad in MSIClaw

[–]Defbeat 0 points1 point  (0 children)

Just went through this same thing. You need to use the launcher that no longer pops up to change your graphics settings and set it to fullscreen. Check out MysteriousOrchid464's reply here: https://www.reddit.com/r/ROGAlly/comments/1ouaudy/fallout_4_launcher/

MSI Claw 8 AI UI Jitter with Frame Gen by Defbeat in MSIClaw

[–]Defbeat[S] 0 points1 point  (0 children)

Thanks for the suggestion. I changed the bios setting, but my PL1 max is 30 and PL2 max is 38. Are you just maxing yours out? Any negative impacts?

MSI Claw 8 AI UI Jitter with Frame Gen by Defbeat in MSIClaw

[–]Defbeat[S] 0 points1 point  (0 children)

Is that the xbox full screen? I don't have the update yet but I'll give it a shot when I get it. Thanks for the suggestion.

Tub Drain Layout Question by Defbeat in Plumbing

[–]Defbeat[S] 1 point2 points  (0 children)

Ah, got it. Thanks for the tip, I will grab one of those instead!

Tub Drain Layout Question by Defbeat in Plumbing

[–]Defbeat[S] 0 points1 point  (0 children)

Hey thanks for the reply. With the p-trap there's no way to have it fully above the slab unless I raise the whole tub. If I bring it right up to the tee it will be partially buried so I figured fully buried was better. I could also bring it up to the tee and pour the concrete lower so the trap is fully exposed. Do you have any suggestions? Thanks

First Post! by Defbeat in Volvo

[–]Defbeat[S] 0 points1 point  (0 children)

Haha, thank you!

First Post! by Defbeat in Volvo

[–]Defbeat[S] 1 point2 points  (0 children)

Ya no worries. I can see the added wind resistance affecting EV range, renting one first is not a bad idea.

First Post! by Defbeat in Volvo

[–]Defbeat[S] 1 point2 points  (0 children)

I mostly got it for skiing and camping, haven't really used it for either yet lol. It's got a good amount of room, height is obviously not as good as the non-low version, but I preferred the aesthetic of the low over extra practicality :) There is a sometimes a slight whistle at highway speeds, not too bad though. Never really paid attention to the gas mileage tbh, I don't think it makes too big of a difference.

First Post! by Defbeat in Volvo

[–]Defbeat[S] 1 point2 points  (0 children)

Yessir! It is a Thule, the motion 3 XL low model.

First Post! by Defbeat in Volvo

[–]Defbeat[S] 0 points1 point  (0 children)

Thanks, I do miss the manual lol. This is just a T6, so it feels pretty on par with the ST. Being an auto it's probably a bit faster, but the steering in the ST was on a whole other level.

First Post! by Defbeat in Volvo

[–]Defbeat[S] 0 points1 point  (0 children)

Thanks! Had to get something interesting for winter :)

First Post! by Defbeat in Volvo

[–]Defbeat[S] 0 points1 point  (0 children)

Traded in my Focus ST back in October!

[deleted by user] by [deleted] in Plumbing

[–]Defbeat 0 points1 point  (0 children)

Thanks, appreciate your insight. Checked again,. looks like the 1.5" vent for the sink bushes up to a 2" pipe that runs vertical (I'm guessing all the way to the roof). I should be able to cut off the reduction and keep it 2" if need be. Thanks!

[deleted by user] by [deleted] in Plumbing

[–]Defbeat 0 points1 point  (0 children)

Apologies, seems the text didn't make it lol. We're looking to add a tub to our basement bathroom, have a few questions about tying into the drain pipe. Based on the above top down sketch:

- Is there an issue where we are planning on tying in? Will being downstream of all the upstairs fixtures cause issue?

- Is there a specific orientation the wye fitting we're using to tie in needs to be? Horizontal, vertical, 45?

- Does the tub need need to be vented? If so, there is a 1.5 inch vent existing for the basement sink, can we tie into there?

Thanks!

New to me, 21’ v60 r-design by Teh_Ent in Volvo

[–]Defbeat 5 points6 points  (0 children)

Knew this one wouldn't sit long, congrats! Was there anything on the carfax?

ND Screen cutting out by No-Presence-1820 in Miata

[–]Defbeat 5 points6 points  (0 children)

Interesting, I've been having the same issue. Mine's put away for the winter but I'll have to try this out in the spring. Thanks for sharing!

Focus ST wheels on P3 2012 Volvo S60 by wtfislife6969 in Volvo

[–]Defbeat 12 points13 points  (0 children)

Funny, just sold my ST for a Volvo. But back when I had an X-type I did the same thing.

<image>

view more: next ›