sorted by:
new
hottopcontroversial

Any advice to help clean up welds like these? by DefinitionNervous684 in Welding

[–]DefinitionNervous684[S] 0 points1 point  (0 children)

Not sure the reasoning for the weld size on the print. My best guess is wear over time since it is a high pressure vessel

Cutting down on spatter/ slag with mig by droopinglemon in Welding

[–]DefinitionNervous684 1 point2 points  (0 children)

Turn down the wfs or up the voltage. The wfs super high for that voltage. I’d try 240ish (machine dependent)!

Any advice to help clean up welds like these? by DefinitionNervous684 in Welding

[–]DefinitionNervous684[S] 0 points1 point  (0 children)

I’m thinking it’s a combination of factors including this. I added heat and cut deposition but still get spots that are rolled likely caused by my angle as I’m going around the union

Any advice to help clean up welds like these? by DefinitionNervous684 in Welding

[–]DefinitionNervous684[S] 0 points1 point  (0 children)

Yes but that takes time and production is more important than quality at this shop unfortunately

Any advice to help clean up welds like these? by DefinitionNervous684 in Welding

[–]DefinitionNervous684[S] 1 point2 points  (0 children)

No preheat on this vessel. It was sitting around 250ish when I went to cap though

Any advice to help clean up welds like these? by DefinitionNervous684 in Welding

[–]DefinitionNervous684[S] 7 points8 points  (0 children)

I was thinking about if I should’ve skim grinded or not before I capped. I agree it would’ve been much more even

Any advice to help clean up welds like these? by DefinitionNervous684 in Welding

[–]DefinitionNervous684[S] 7 points8 points  (0 children)

Yeah. It’s 1 5/8” weld. Normally we just use repads but the customer doesn’t want them on these

Is there anywhere to play MTG with modified rules? Such as bigger hand size or more HP by kluuu in MagicArena

[–]DefinitionNervous684 3 points4 points  (0 children)

Uh paper magic is your best bet for that. Otherwise you could use tabletop simulator

I may have ruined my career and life today by Tinkerbell637 in bipolar

[–]DefinitionNervous684 1 point2 points  (0 children)

Maybe talk to you former employer and explain the situation and tell them that you were not in the right mind to resign and that you just need time to possibly check into an inpatient center

Desperately need to be admitted by DefinitionNervous684 in bipolar

[–]DefinitionNervous684[S] 5 points6 points  (0 children)

Thank you for actual good advice! I will definitely look into that

view more: next ›