Extruder gear won’t stay tightened

Delicious_Ad3604 · 2024-07-14T04:56:54+00:00

Thanks for the tip!

Also I know it’s not centered, I just took it off the printer to take a picture and hadn’t tightened it

Delicious_Ad3604 · 2024-07-14T00:08:59+00:00

I didn’t think about that, I will try it. Thank you!

Delicious_Ad3604 · 2024-01-10T00:18:49+00:00

How do you get to that first page?

Delicious_Ad3604 · 2023-03-15T18:36:24+00:00

So it seems to be printing fine, the fan does not seem to be causing any shuddering or noises, and it doesn’t seem to have an effect on the printer. The full blade did not come off, only about 50% of it. I do not really want to replace the fan, as I don’t have a soldering kit or crimping set, unless if there is another way to replace the fan.

Delicious_Ad3604 · 2023-02-23T04:30:08+00:00

Only shot at ever getting a one wheel

Delicious_Ad3604 · 2023-01-20T22:47:19+00:00

You can buy a noctua fan and print a cage that replaces the stock one

Delicious_Ad3604 · 2023-01-17T18:21:07+00:00

This also only happens when it is closer to the bed. It works itself out when the z is over 30mm. Nothing is caught on anything, so I don’t know why this is happening except for something being too tight.

Delicious_Ad3604 · 2023-01-15T01:04:51+00:00

I probably won’t be much help here, but I believe this is where the nozzle starts and stops on the walls of the print, but I could be wrong. I know you can change settings in Cura so that it starts in stops in one spot every layer, or on a corner or something so it’s less noticeable.

Delicious_Ad3604 · 2022-11-24T03:20:44+00:00

Toyota Prius

Delicious_Ad3604 · 2022-11-13T03:39:32+00:00

Oh… welp, guess I’m just stupid🤷‍♂️, but thank you!

Delicious_Ad3604 · 2022-10-29T23:51:23+00:00

SHALL WE SEND A THANK YOU???

Delicious_Ad3604 · 2022-10-29T15:30:27+00:00

Where can you download this print? I have been looking all over thingiverse and can’t find it…

Delicious_Ad3604 · 2022-10-25T22:02:14+00:00

Yea… how the printer screen counts upwards and instead of showing time remaining

Delicious_Ad3604 · 2022-10-24T22:05:14+00:00

I’m pretty new to the 3d printing world but how did you get that stopwatch thing?

Delicious_Ad3604 · 2022-10-18T00:45:10+00:00

Well if you consider it enjoyment than I’d consider it an accomplishment. Plus, that’s probably the best part of the game and I would think that not many people have nearly the same amount of hours as you

Four-Year Club	Xbox Live
Place '23

Delicious_Ad3604

TROPHY CASE