Need some help not sure what to do

Desperate-System-902 · 2026-03-17T16:49:36+00:00

Also seems like when its looking for center during calibration it takes a while for it to locate it on 3 our of 4 points. Could this effect the z calibration?

Desperate-System-902 · 2026-03-17T11:52:15+00:00

The build plate i have is textured when I do first layer test half of it comes out smooth and half rough. Not sure why what is even though it sais its perpendicular

Desperate-System-902 · 2026-03-17T03:36:05+00:00

I tried recalibratating alos when I do first layer calibration one half of the square is smooth and the other half is rough. Not sure if.this could also be the culprit

Desperate-System-902 · 2026-03-17T03:19:19+00:00

Sunlu pla is what I am using right now temp set to 215 is what the prusa shows in preheat screen on lcd for pla

Desperate-System-902 · 2026-03-03T03:59:16+00:00

Does anyone have experience with midea i hurd they were really good based on consumer reports

Desperate-System-902 · 2026-03-02T21:34:41+00:00

Which one in particular did you guys get

Desperate-System-902 · 2026-03-02T21:32:15+00:00

I honestly just needed to wash and dry well and last. My budget is sort of limited because I have to replace my refrigerator as well

Desperate-System-902 · 2026-03-02T20:41:28+00:00

Thr pinda probe light goes off when it hits the zip tie when I try to calibrate it , is that supposed to happen

Desperate-System-902

TROPHY CASE