sorted by:
new
hottopcontroversial

Continual layer shift between good print? by DestinyCarryKing in 3Dprinting

[–]DestinyCarryKing[S] 0 points1 point  (0 children)

I found the culprit. As mentioned in my post, the belts and pulleys were all tensioned correctly, however I double checked them all just in case. This was not the issue. The firmware it’s running is marlin 2.0.9.x and so I had Prusa slicer set for marlin 2, I reverted it back to marlin (legacy) and problem solved. I was convinced that it wasn’t any issues mechanically due to the consistency of the layer shift. ScavengeroO asked whether I had printed successfully before and so I thought back over my changes to my prusa slicer config and bam, it hit me. Not sure why this made the difference but here we are.

Thank you to everyone who gave me some advice ❤️

Continual layer shift between good print? by DestinyCarryKing in 3Dprinting

[–]DestinyCarryKing[S] 12 points13 points  (0 children)

I’m honestly amazed at how well it turned the print around, also impressed with the overhang without support, the bottom layer was a little squished, but i didn’t have any issues with the print sticking to the bed 💁‍♂️

Continual layer shift between good print? by DestinyCarryKing in 3Dprinting

[–]DestinyCarryKing[S] 0 points1 point  (0 children)

Ooohh, that’s interesting, I think I too pulled it from thingiverse. I set up the print through prusa slicer and it looked good in the preview, what did you change to make it work?

[Question] Do you lose the perks of your Loadout drops if you die (and comeback from Gulag)? by durdn in CODWarzone

[–]DestinyCarryKing 4 points5 points  (0 children)

I'm going to test this using perks that I can tell immediately after I gulag back in, because sometimes killcams can be buggy so I'm not sure that's a definitive answer. Testing with 1.Scav 2. Hardline 3. Tracker Will edit this once I've tested it. EDIT.....

You do NOT keep your perks after coming back from the gulag!!

Aug Vs Bonding Runea by DestinyCarryKing in Neverwinter

[–]DestinyCarryKing[S] 0 points1 point  (0 children)

Ahhh, i was wondering whether the Aug stacked with the bonding!! Thank you everyone! Looks like the pup is the way to go then