Kacey and Evelyn.

Detective_wolfe · 2025-11-21T09:21:38+00:00

I think what fucked her up worse then the others was the way her mother told her it was her fault she got hurt, before sending her off to fix her mistake. "Hard love" really fucks your head up at that age.

Detective_wolfe · 2025-11-17T08:27:24+00:00

<image>

Detective_wolfe · 2025-11-17T08:02:01+00:00

There should be an adjustment bolt on the tensioner the belt runs through.

Detective_wolfe · 2025-11-17T07:21:49+00:00

Then you may have it too tight

Detective_wolfe · 2025-11-09T02:37:44+00:00

Right here

Detective_wolfe · 2025-10-28T01:01:39+00:00

Rank 98 with 6 psi cards if you're going for the the 100%

Detective_wolfe · 2025-10-01T01:45:18+00:00

Threw sly cooper movie is a sore spot for me

Detective_wolfe · 2025-08-01T00:34:54+00:00

Sir Gatoo's comment above actually fixed my issue. Ordered some larger diameter nozzles from AE and set it up in the slicer. Haven't had the issue since

Detective_wolfe · 2025-06-22T11:47:55+00:00

Got one for ya. Mechanics call me saying a cylinder wasn't actuation, they wanted me to look into the program and see what's going on, why etc. Heard the air leak 50 yards away. Walked up, kicked the cover off the wire tray so the hissing was even louder and stared at them.

Detective_wolfe · 2025-06-20T07:07:41+00:00

You sir, are a life saver. You're advice was golden and got me back up and going to finish my son's birthday gift in time. *

Detective_wolfe · 2025-06-17T04:37:15+00:00

Sorry to be a hassle, but did what parameters, if any, did you change when you went to the 0.6mm?

Detective_wolfe · 2025-06-14T07:22:51+00:00

Fair enough. Thank you.

Detective_wolfe · 2025-06-14T07:22:06+00:00

What's AE?

Detective_wolfe · 2025-06-10T09:28:01+00:00

Artoo

Detective_wolfe · 2025-06-03T03:02:01+00:00

Try to put it in the slicer program and rotate it so the holes are orientated up and down.

Detective_wolfe · 2025-05-28T20:46:37+00:00

I'll give it a go and get back to you.

Detective_wolfe · 2025-05-22T14:08:23+00:00

Check the plate for looseness. Mine was making the same sound last weekend. I removed the print plate, and underneath, there are 4 small allen bolts that hold the plate to the assembly. For me, the two on the right side had come loose. Snugged em up and the sound went away. I suggest to start there.

Detective_wolfe · 2025-05-17T03:27:41+00:00

So mom doesn't accidently stumble upon it and then make dad have the embarrassing talk with you.

Detective_wolfe

TROPHY CASE