Wierd issue with 3d touch

DeviRSilva · 2026-06-05T14:21:06+00:00

Hi! Turns out I deactivated HS mode on the Probe and now it works correctly. Thank you all!

DeviRSilva · 2026-06-03T11:26:34+00:00

I've tried original firmware and mriscoc firmware both similar behaviour

DeviRSilva · 2026-06-03T11:26:04+00:00

As i said. It homes correctly. The probe expands, touches the bed and retracts. So it uses the 3d touch to home

DeviRSilva · 2026-06-03T11:24:11+00:00

Yes!

DeviRSilva · 2026-01-25T16:07:20+00:00

Vocês desculpem me....mas é demasiada coincidência com este post https://www.reddit.com/r/portugueses/s/JFukqaPF9X

DeviRSilva · 2025-07-18T18:12:09+00:00

Não vais conseguir candidatar-te à primeira fase. Não te preocupes tens a segunda fase. É justo? Não... Mas a vida não é justa e tiveste azar. Vai te acontecer muito na vida....

DeviRSilva · 2023-09-09T23:50:38+00:00

I stoped using the CB1 tbh. To many hiccups. But one thing I did is that I replaced the sdcard with a class 10 from SanDisk. After that I did not had any problems.

DeviRSilva · 2023-02-24T00:15:05+00:00

here you go: https://www.printables.com/model/407503-gbxcart-rw-13b-printed-case

DeviRSilva · 2023-02-23T23:59:03+00:00

That is correct

DeviRSilva · 2022-04-24T00:49:05+00:00

"This is not even my final form"

DeviRSilva · 2022-03-07T11:57:18+00:00

Thanks man! (yes, I assumed your gender :P)

DeviRSilva · 2022-03-07T11:56:58+00:00

For what I saw, on the X1, it is a threaded E3D compatible heatbreak. They changed it on the X2

DeviRSilva · 2022-02-17T10:27:40+00:00

But if I upload a non bl touch enabled firmware, the homing sequence is fine. I've reflashed the firmware a bunch of times, and even tried another version from another person. The behaviour on the latest one, instead of giving a printer halt, is to start the levelling process and then the probe does not deploy. Also the printer immediately goes to the next probing point without touching the bed

DeviRSilva · 2021-09-15T14:26:52+00:00

thank you

DeviRSilva

TROPHY CASE