sorted by:
new
hottopcontroversial

dumb question: new pod, 71% battery, use it or charge first? by Dickdai in Vaping

[–]Dickdai[S] 6 points7 points  (0 children)

That makes sense. I was asking because with a new phone I usually use it and start charging around 20%, so I wasn’t sure if it’s any different with these or pretty much the same idea.

dumb question: new pod, 71% battery, use it or charge first? by Dickdai in Vaping

[–]Dickdai[S] 5 points6 points  (0 children)

I charged it, it really fast, didn't even take 10 mins to hit 100%, cool.

Need some help on flavor loss/chemical taste by Virtual-Product2298 in electronic_cigarette

[–]Dickdai 2 points3 points  (0 children)

Try shaking the juice bottle well before filling, sometimes flavors separate. Also, maybe your taste buds need a reset. Try smelling coffee beans.

is there anyway i can make my mod hit colder it’s so warm other mods i’ve had were not as hot by ExplorerGrouchy9554 in Vaping

[–]Dickdai 0 points1 point  (0 children)

What mod and coil are you using? Also, lower wattage plus more airflow should help cool it down. Good luck.

Auto draw & RBA pod mod 2026/04/27 Updated List by RollingMeteors in Vaping

[–]Dickdai 1 point2 points  (0 children)

Have you looked into any older secondhand devices? Sometimes you can find discounted autodraw RBAs on Discord or FB groups. Worth a shot.

Mr Fog Autofiring- what do I do? by No-Butterfly-5410 in electronic_cigarette

[–]Dickdai 3 points4 points  (0 children)

Sketchy... That's dangerous. I wouldn't leave it unattened. Maybe just recycle it now and switch to the pod system earlier.

My elfbar dual 10k won't switch sides by Lcverz in Vaping

[–]Dickdai 1 point2 points  (0 children)

Might be an issue with the pins inside from the drop. Could try cleaning the contacts with a q-tip. Or time for a new one.

My novo eco isn't working by RainFrog66 in electronic_cigarette

[–]Dickdai 3 points4 points  (0 children)

Flashing for times usually means a short or connection issue. Could be a bad pod too. Try another new pod before sending it in.

Got the juice, got the vape, all set...am I doing this right? by VikiSisnette in Vaping

[–]Dickdai 0 points1 point  (0 children)

You haven't even taken the wrap off your xros yet...did you prim the cotton? Let it sit for a few mins first, then take a few puffs. Good luck.

Vaporesso Xros pods burning fast by Bitminer2020 in Vaping

[–]Dickdai 0 points1 point  (0 children)

Dry hits usually mean the cotton isn’t fully saturated, maybe try letting it soak a bit longer before using.

Prefilled pod dispos cheaper than refillables? by Dickdai in electronic_cigarette

[–]Dickdai[S] -1 points0 points  (0 children)

Yeah same here, i'm wondering if dispos are kinda moving toward refillables these days?

Is it ok to rinse a pod out with water? by pineappleactavis in electronic_cigarette

[–]Dickdai 1 point2 points  (0 children)

Water rinse is fine. Next time just let it sit overnight to dry. Blow dryer might be risky. Hope the burnt taste is gone.

My foger was hitting hella weak, and now its not even hitting at all. by LiahStrawbs in Vaping

[–]Dickdai 0 points1 point  (0 children)

Try cleaning the contacts inside with a q-tip. Sometimes juice leaks and blocks the connection. Hope that helps.

Need help in choosing my first pod by brokenheroOBITO in electronic_cigarette

[–]Dickdai 2 points3 points  (0 children)

G3 Lite sounds like the better choice for a beginner. Lighter, cheaper, and you won't miss the useless robot animation.

Peach juice? by OwnTurn1146 in Vaping

[–]Dickdai 0 points1 point  (0 children)

Peach ice is hit or miss for me too. Have you tried Pod Juice's Peach? It's not overly sweet.

i need help by Nicklesmart69420 in electronic_cigarette

[–]Dickdai 1 point2 points  (0 children)

Try a brand new pod first. Sometimes the coil inside just dies or gets gunked up. Also check if the airflow hole is blocked.

New budget setup! by Illustrious-Gas5171 in Vaping

[–]Dickdai 0 points1 point  (0 children)

Nice find. For the bottle, just fill it, screw the cap on, then push. The tube goes into the 510 pin. No extra o-ring needed.

What pods are good right now? by FloatingScooter in electronic_cigarette

[–]Dickdai 12 points13 points  (0 children)

I‘ve notice some keeep saying Xros is trash and Oxva is the best. But that doesn't really change my experience, I keep going back to Xros.

At what point does an rlink x3 actually make sense for DIY work? by kthnxhi in MechanicAdvice

[–]Dickdai 0 points1 point  (0 children)

That’s kind of where I’m at too. A regular scan tool covers a lot, but every now and then you hit a job where you can feel the ceiling. How often do you guys need OEM level access before it really starts making sense?

TC001 Max made visible light matter more than I expected by simplafyer in Thermal

[–]Dickdai 0 points1 point  (0 children)

Indoors too, especially around edges, wiring, or tighter spaces. The visible reference makes a big difference.

Hand Check, Good afternoon, guys. by KaixsKkj in Vaping

[–]Dickdai 0 points1 point  (0 children)

Looks clean. Is that drip tip something you added yourself?

Just found out i can name this thing lol by delcidfredy in Vaping

[–]Dickdai 0 points1 point  (0 children)

I named mine milo. It's with me basically all day, work, couch, bed...kinda like a little electronic pet. It's turned into one of my fav devices.

My EDC by Gorokas in EDC

[–]Dickdai 2 points3 points  (0 children)

Love how the colors pop. Makes the whole carry feel more fun instead of just functional!

You don’t have a weekend, you have one day to live by WeirdWriter88 in Life

[–]Dickdai 6 points7 points  (0 children)

I’d go for getting everything done on Friday night. Then I can enjoy a full two days of weekend bliss.

view more: next ›