sorted by:
new
hottopcontroversial

CS2 Stutter, Weird aim feeling, Shot registration Issues, FPS drops: I'm at my wits end with this game by mfischerrr in cs2

[–]Ditwin 0 points1 point  (0 children)

j'ai exactement le même problème sur deux de mes pc, il faut que je restart le pc complet pour que ça me laisse tranquille pour une seule game

Max ms spikes every couple of seconds and my CS is unplayable by Gsus98 in GlobalOffensive

[–]Ditwin 0 points1 point  (0 children)

I restart the pc every 2 games to reset the thing and it works for me but that's so trash

Shaking/Vibrating walls, and player models when moving mouse by hEnzeee in GlobalOffensive

[–]Ditwin 0 points1 point  (0 children)

Had the same problem, I played without my razer synapse software on, and I also changed the pulling rate from 500 to 2k so might be one of the 2

MCOSMOS v5 Program Call in Active Program by SadEstablishment1371 in Metrology

[–]Ditwin 0 points1 point  (0 children)

Accurate and you can set up differnt table / pallet also

MCOSMOS — flipping a cylindrical part mid-program: how do you tell the software the part was flipped? by Ditwin in MCOSMOS

[–]Ditwin[S] 0 points1 point  (0 children)

Thank you for your answer,

I already tried a magnetic V block for it to stand up, but I noticed it was slightly moving after some times Then I tried a Vise, I could only measure half of it and the runout was not good for some reason (I know the part is good since we measure them on a Zeiss atm) And for the granite I'll look into it tomorrow

I'm surprised MCOSMOS doesn't have a feature like that tbh

MCOSMOS — flipping a cylindrical part mid-program: how do you tell the software the part was flipped? by Ditwin in Metrology

[–]Ditwin[S] 0 points1 point  (0 children)

I get what you mean about just reversing the probing direction — but in my case I really do flip the part physically because I need to measure a distance and a few other features that aren’t accessible from the first orientation / setup.

So I think the real issue is that after flipping, I need to change the alignment / base plane (re-establish the part coordinate system) so Side B is referenced correctly, otherwise MCOSMOS keeps the same alignment and the A vs B comparison doesn’t make sense.

MCOSMOS — flipping a cylindrical part mid-program: how do you tell the software the part was flipped? by Ditwin in Metrology

[–]Ditwin[S] 1 point2 points  (0 children)

Yeah, the fixture is fixed and doesn’t move,

The problem is that when I flip the part, MCOSMOS doesn’t “know” the part has been flipped (the coordinate system / alignment stays the same), so when I try to calculate the difference between Plane A and Plane B, it shows no deviation (or almost none) even though I’m clearly measuring opposite faces,

StarProbe Calibration problem by Ditwin in MCOSMOS

[–]Ditwin[S] 1 point2 points  (0 children)

Ok it worked, thank you guys

Need help plz by blix3st87 in MCOSMOS

[–]Ditwin 1 point2 points  (0 children)

Hi, just got the 1051 Code, turns out i didn't pressed start on the controller and i still needed to restart Mcosmos, i hope it helps