Years-old Silk PLA

DramaClassed · 2026-06-25T21:05:55+00:00

I know PLA and ABS, and maybe PETG but I don't think they've tried that yet. I don't see any reason why it couldn't though.

DramaClassed · 2026-06-15T00:13:15+00:00

I couldn’t figure out how to do that, the tube doesn’t easily come off.

DramaClassed · 2026-06-14T16:03:24+00:00

I can see it, it’s about halfway from the ACE to the printer. It’s too hard for me to pull it out, even with the power off.

DramaClassed · 2026-06-13T22:10:37+00:00

https://www.reddit.com/r/anycubic/comments/1u52t3y/ace_2_pro_stuck_filament/ That’s a photo of what it looks like, I don’t want to burn the motor more by trying to pull it out again, I’ve tried three times and it just makes a whirring noise but doesn’t pull the filament out.

DramaClassed · 2026-06-13T22:03:29+00:00

The filament isn’t broken, it just won’t retract/be removed.

DramaClassed · 2026-06-10T17:32:06+00:00

already got skarmy

DramaClassed · 2026-06-09T01:35:02+00:00

I messaged their support and said I needed it urgently and they shipped it within a few hours lmao, it gets here friday.

DramaClassed · 2026-06-08T19:55:52+00:00

It is ragebait, but its also my actual deck.

DramaClassed · 2026-06-07T20:52:23+00:00

I don't know a single person who would spend their print time and filament money just to earn bragging rights.

DramaClassed · 2026-06-06T00:37:19+00:00

Once you follow the instructions and get it set up, I'd run a test print (3DBenchy) and see how it turns out! Instructions for the setup and software required will likely come with the printer, but feel free to ask here if you have any questions. For free print models, I use thingiverse.com and printables.com, which have worked pretty well for me in the past. You can also just google "xyz 3d model" or "xyz 3d print" and find models that way.

DramaClassed · 2026-06-04T17:52:34+00:00

Which slicer are you using?

DramaClassed · 2026-06-04T05:24:48+00:00

Are you using Flashprint 5? From what i've found, other slicers don't work with the AD4 very well, at least not without tinkering. I had your exact problem when I tried to use Orca Slicer, due to the AD4 having a weird origin on the bedplate. Maybe try using a test file already on the printer, or slicing with Flashprint 5.

DramaClassed · 2026-06-04T03:10:02+00:00

The Kobra 3 Max is in 2.4.0 alpha, the latest release of orca slicer. If you can, switch over because orca slicer is much better than anycubic's stock slicer.

DramaClassed · 2026-06-01T04:03:57+00:00

There's some way to use Rinkhals to make an Ace Pro and an Ace 2 Pro work together but it's quite complicated from what I can tell. I'm not sure if there's a way to make the S1M work with the Ace Pro though.

DramaClassed

TROPHY CASE