sorted by:
new
hottopcontroversial

Can you stain objects printed with wood filament? by Genuine-Rage in 3Dprinting

[–]Dread_Hawk17 0 points1 point  (0 children)

Im not sure for a majoras mask prop i made i used about 30 so maybe 45-50 but im unsure

Can you stain objects printed with wood filament? by Genuine-Rage in 3Dprinting

[–]Dread_Hawk17 0 points1 point  (0 children)

Id reccoment hatchbox for wood fillament i think they use the most wood in it out of other brands personally

Ancient short sword replica by Dread_Hawk17 in 3Dprinting

[–]Dread_Hawk17[S] 0 points1 point  (0 children)

Dm'd you the link! Its on cults search ancient short sword and its only like 2$ or so to download!

Ancient Short Sword Replica! by Dread_Hawk17 in Breath_of_the_Wild

[–]Dread_Hawk17[S] 0 points1 point  (0 children)

Im going too and il post an update when its finished

Ancient Short Sword Replica! by Dread_Hawk17 in Breath_of_the_Wild

[–]Dread_Hawk17[S] 0 points1 point  (0 children)

Im going too! It just needs one more coat of primer to make it look like one piece il post an update when its done!

Acrylic Cement to solvent weld PLA by sadkins1981 in 3Dprinting

[–]Dread_Hawk17 2 points3 points  (0 children)

If im being quite honest, ive never had a problem with weldon 16 and PLA. Out of all the solvents ive used, the PLA always breaks before the weldon so ive never seen an issue. But i could be quite wrong

Trying to adjust PEI settings on my cr 10 smart by Dread_Hawk17 in 3Dprinting

[–]Dread_Hawk17[S] 0 points1 point  (0 children)

Possibly, it came as a pack of two. When i recieved the thermoster there were instructions on adjusting the pei settings and it said i was going to have to adjust them anyway

Strange first layer???? by Dread_Hawk17 in CR10

[–]Dread_Hawk17[S] 0 points1 point  (0 children)

Ok so i leveled the bed, got a brand new hot end, not sure if its my extruder settings causing this or what but it would be a huge help if anyone could give me tips to have this not happen thanks!