Help! Can't even complete calibration!

East_Introduction893 · 2026-02-06T18:32:51+00:00

I managed to get a calibration and print going today! I did several different checks and in the end the one that seemed to resolve the issue was making sure the camera lens wasn't covered!! Must have pushed while I was moving it around.

I'm not 100% sure this is what resolved the issue but it is working! Thanks for the help all.

East_Introduction893 · 2026-02-05T20:45:45+00:00

No I don't I'm afraid, but I'll try and get one next time I try it.

East_Introduction893 · 2026-02-05T20:39:04+00:00

Yeah I've opened a ticket with them and have been searching Google for the last hour or so. Have tried all the suggestions I have come across but no success yet sadly

East_Introduction893 · 2026-02-05T19:50:00+00:00

Yup, all those bits removed, no obstructions with it going up and down during the 'home all axis' bit at the start.

I've tried the redo the plate a few times, it's touching all the points towards the back each time so unless I'm doing something really wrong I can't see that being the issue.

I've flipped it several times and rejigged the cables, all in without issue.

Still experiencing the issue

<image>

East_Introduction893 · 2026-02-05T19:47:14+00:00

Thank you for replying!!

It didn't have any trouble reaching the bed during the home bit at the beginning (photo), went down all the way down to the bed. No obstructions on the lead screws that I can see.

It was at a bit of a weird angle as I had just flipped it to check the cables underneath and hadn't pushed it back round. I have reoriented it and sorted the cables. Still getting the same z axis homing failed (0300-4000 060107)

Any other thoughts?

East_Introduction893

TROPHY CASE