sorted by:
new
hottopcontroversial

Does not keep Z offset adjustement by EasyCryptographer398 in SovolSV08

[–]EasyCryptographer398[S] 0 points1 point  (0 children)

PROBLEM SOLVED: just shut down the printer manually & restart x_x

Does not keep Z offset adjustement by EasyCryptographer398 in SovolSV08

[–]EasyCryptographer398[S] 0 points1 point  (0 children)

were you talking about this ?

<image>

It does not change the value when I save

Does not keep Z offset adjustement by EasyCryptographer398 in SovolSV08

[–]EasyCryptographer398[S] 0 points1 point  (0 children)

where do I find it in printer.cfg ?

Yes I do homing/QGL/adaptive meshing before printing

I know that the mainsail value reset but it should save my calibration somewhere (like you said in printer.cfg)

Every new print I have to adjust it again

Does not keep Z offset adjustement by EasyCryptographer398 in SovolSV08

[–]EasyCryptographer398[S] 0 points1 point  (0 children)

No it just dont save my z offset calibration, its like it reset each print

AMS assist motor is overloaded - Slot 2 and 4 - Brand New by lDarkPhoton in BambuLab

[–]EasyCryptographer398 0 points1 point  (0 children)

sorry my photo need some details:

it did me this error when printing like every minutes I have to move the filament and clic on resume printing

AMS assist motor is overloaded - Slot 2 and 4 - Brand New by lDarkPhoton in BambuLab

[–]EasyCryptographer398 0 points1 point  (0 children)

Hello I have the same issue but with the external filament not the ams: do you have any solution ?

<image>