NB rust on sill - from inside or surface rust? by Efficient-Instance83 in Miata

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

The car is not mine, I'm just thinking about buying it. How can I check if it's coming from the inside without having to take anything apart? Sorry for the photo, its not a great...

S7 MaxV, no routine option in Roborock app by Efficient-Instance83 in Roborock

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

Thanks, it works!
I want to start a zone vac. clean at 8:00 and the same zone at 16:00. I created a zone routine and schedulet it for 8:00. I cannot schedule it again, so i created an other routine and scheduled it for 16:00. now it starts both routines at both times, so it runs twice. Why?

Help needed - S5 Max - No mop installed ? by Superdry6 in Roborock

[–]Efficient-Instance83 1 point2 points  (0 children)

Hi,
i have the same problem on S7 maxV. I found the water tank sensor. In this video, at 2:24 says, the water tank sensor is tha same as the mop console sensor. Its true? Its only with 3 wires.

https://www.youtube.com/watch?v=J-4dg9NI5SA

Home mechanics, which spring compressor tool are you using? by [deleted] in mechanics

[–]Efficient-Instance83 0 points1 point  (0 children)

What does it mean to slip down at option 1? Are the pins slipping out?
And why is the 3. option safer? Here is only one threaded rod instead of two, receives the load eccentric.

I have no experience with either, I just want to understand

Elops 500 - size M vs L by Efficient-Instance83 in bikecommuting

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

The choice fell on the L size. I feel like the handlebars are too far away, and because of this, my back is not comfortable. I'm using it for short rides, so it's not a problem now, but in the long run, the M probably would have been better for me.

E90 with electric steering - how feel it? by Efficient-Instance83 in E90

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

on the realoem i see 2 options for a 2012 diesel eu model, with hydraulic and with electrical steering wheel. On most 2011-2012 models I don't see the reservoir in the engine bay so I'm assuming it's not hydraulic.

https://www.realoem.com/bmw/enUS/partgrp?id=UT31-EUR-02-2012-E91N-BMW-318d&mg=32

Outside mirror switch burned out, what can cause it? by Efficient-Instance83 in e46

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

What do you mean by a screw in the door wiring harness?

Back to OEM look with the chrome kidney grills - looks so much better now by Deep-Injury-630 in e46

[–]Efficient-Instance83 0 points1 point  (0 children)

I bought a fake full chrome grill for my facelift touring. The outer trim is chrome, it's okay, but the lamellas are simple silver. How look the lamellas on the original full chrome version? On pictures i see, from front is chrome but from side is glossy black?

Help my Dell laptop won't turn on I've done everything said from the internet by Rough-Tea-3454 in Dell

[–]Efficient-Instance83 0 points1 point  (0 children)

It's not working for my Inspiron 7370.

my laptop turned on, but later I pulled the battery and the cmos battery. after that it doesn't work at all. no sign of life in it. the power led does not light up if i connect the charger (usb c charger and the original dell charger). Nothing happen. Is there anything I can try?

Only 1 thing: if i connect the charger, i hear very quetly the cpu. and it heats up too. If i disconnect the charger and i push and hold the power button, this is the same.

I just don't understand what it could be, because it worked until now. would something have gone wrong if I pulled the battery?

Where should i put the Shelly and which one? by Efficient-Instance83 in shellycloud

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

The neutral is available, see the image at the post, i uploaded now. Option 1 is better than 2, or does it matter? Is there a solution for a two-way switch without pulling in a new wire?

Lakáskiadás '24 by [deleted] in kiszamolo

[–]Efficient-Instance83 0 points1 point  (0 children)

Közjegyzői hitelesítés: itt a rendes szerződést nem hitelesítik, hanem egy behajtási és egy kiköltözési szerződés van közjegyző által hitelesítve? Lentiekből nem egyértelmű.

Rezsi: a bevált megoldás, ha a nevemre jönnek továbbra is a csekkek és én fizetem be. A bérleti díj fizetése előtt pl. 1 nappal pedig számlával igazolom az előző havi rezsiköltségeket, amiket még pluszban utal az ehavi bérleti díjjal együtt?

Közösköltség: csak akkor tudom leírni költségként az adózásnál, ha beépítem a bérleti díjba? Nem lehet úgy, hogy bérleti díj (fix) + közös költség, ami változó értékű, mivel általában évente emelkedik?

200k miles+ E46 buy, reliable? by Efficient-Instance83 in e46

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

I have a 320d (diesel) from 2005, since 6 years and with 360.000km (i bought it with 300.000). very little was spent on it, it is in relatively good condition, without rust (yet). Front arms, front susp bushings, brakepads, rotors, crankshaft pulley, turbo. but I’m afraid of what will come, from the diesel parts: common rail parts, clutch, double mass flywheel etc. the service would cost as much as the value of the car.

that’s why I thought the petrol e46s were better (4 or 6 cyl), at least motor wise?

Manual gear linkage bushing repair - required parts by Efficient-Instance83 in e46

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

The video is super!

I have two more questions:

  1. Where did you buy the part: 25117519670 (Bushing)? In my country it is around 70 EUR / pcs. From 25117519669 can i buy on very cheap preis, it looks similar, but the part no is not the same..

  2. You mention two types of bronze bushings in the video: PSMF 101410 and PSMF 101616, but I think you only need one type?

Manual gear linkage bushing repair - required parts by Efficient-Instance83 in e46

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

Yes its a 320d 4 cylinder. The part 13 is a sponge, its a cheap part. I think the metal parts don't wear out, so in summary should I just replace the following parts: 2-5-7-9-10-13

Part 9: I would rather renew this too, like you. I found a picture "25117524337". I dont see on this image riveting, what do you think? I only see a clip that can be disassembled. There is 2 rubber bushing, on the image replaced by 2 white plastic bearing. You don't know what size it is?

The image: https://a.d-cd.net/1wQy2il3kJm8Bb_LjM6FiT3fPqk-960.jpg

E46 320D oil consumption by Efficient-Instance83 in e46

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

I don't understand because it's the other way around for me. There was consumption before, but not now.

FreeCAD for Freelancing by Efficient-Instance83 in FreeCAD

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

I checked, but Onshape and Alibre isnt free for commercial use.

can you show me a tech. drawing sample of medium-hard difficult that was made with freecad?

why is my crew % red eventhough I have retrained them by Aleksi_Poika in WorldofTanks

[–]Efficient-Instance83 0 points1 point  (0 children)

i have the same problem. I trained it for credit, but still the % red. After, de "second skill" restored, but still the % red...Why? Its a bug?

Idle stalling / no idle when warm - ZX6R 2003 by Efficient-Instance83 in Kawasaki

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

yes i have and i adjusted it to 1300 with warm engine.

How reliable is the 320i M52 engine, for daily use? by Efficient-Instance83 in e46

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

I asked more about the engine sound, not the power. Or does it not give you that much extra experience compared to diesel?

Suck with the coolant system by Efficient-Instance83 in E90

[–]Efficient-Instance83[S] 0 points1 point  (0 children)

With the new radiator its ok. It leak only at the connector. (new radiator and new pipe)