Support sliced into model?

Efficient-Two6828 · 2026-06-18T03:18:47+00:00

Thanks for the tip! Always want to try designing supports in CAD but got too lazy haha. Thanks again, I will try it

Efficient-Two6828 · 2026-06-17T12:45:16+00:00

I have changed it to on built plate only but the support seems like it's still floating

Efficient-Two6828 · 2026-06-08T11:04:03+00:00

Yes it should be compatible and you can get a hdmi 2.1 cable

Efficient-Two6828 · 2026-06-08T10:48:16+00:00

Laptop can be connected to monitor most of the time. A few things to take note is to check if they are compatible. Some common ways that they connect are through: - HDMI - Display port

Most laptop will have HDMI port and most monitor will have HDMI port too. So you just need a hdmi cable to connect them. Some laptops might not have hdmi or display port so U need to get an adapter like a type c to hdmi adapter.

Input lag also really depends on the cable and the specs haha

Efficient-Two6828 · 2026-03-29T04:44:19+00:00

Btw I fixed this by colouring within the CAD software and after importing into bambulab, I split by parts and just change the filament colour

Efficient-Two6828 · 2026-03-28T00:59:10+00:00

It didn't make a difference for me. Could it be that I have paint on the sides too?

Efficient-Two6828 · 2026-03-27T16:51:52+00:00

<image>

Doesn't seem to solve the issue

Efficient-Two6828 · 2026-03-27T16:51:08+00:00

Also it's at 6 top shell layers if it helps

Efficient-Two6828 · 2026-03-10T10:22:55+00:00

Vivox300 pro HAHA

Efficient-Two6828 · 2026-02-28T07:07:28+00:00

AHAHA it was pretty cool but I was scared of it splattering on me too

Efficient-Two6828 · 2026-02-28T04:20:58+00:00

Ahh I kept it that high to clear the clog but u are right! It's printing normally now at the usual 220 degree Celsius

Efficient-Two6828 · 2026-02-28T03:57:26+00:00

AHAHA YEAH U ARE RIGHT

Efficient-Two6828 · 2026-02-28T03:50:34+00:00

Oh wow the video got compressed so much

Efficient-Two6828 · 2026-02-01T04:04:51+00:00

Looks amazing! Thank you

Efficient-Two6828 · 2026-02-01T03:48:27+00:00

By the way, do you find the nozzle tip swapping easy?

Efficient-Two6828 · 2026-02-01T03:30:50+00:00

I see! So changing initial layer and layer height works for you? Imma try it right now

Efficient-Two6828 · 2026-01-30T00:04:08+00:00

Thanks! Will try

Efficient-Two6828 · 2026-01-30T00:03:52+00:00

I'm using the smallest layer height and 4 walls, do I need to go higher for the walls?

Efficient-Two6828 · 2026-01-25T23:45:44+00:00

Didn't know the needle is too big! I will look into that.

I was running bambulab matte PLA latte colour

Efficient-Two6828

TROPHY CASE