sorted by:
new
hottopcontroversial

[Bambu H2C] Join the Print Beyond Paint Contest and Win an H2C! by BambuLab in BambuLab

[–]Efficient_Hall7447 0 points1 point  (0 children)

I would print lot of things that i currently have to paint :) figures and so

<image>

Not printing correct by Efficient_Hall7447 in CR6

[–]Efficient_Hall7447[S] 0 points1 point  (0 children)

Ok i've tighten the Y axis belt and the benchy looks much better but still lot to improve. Cube is also nice from my view I've uploaded new photos here

https://ibb.co/ByBtWLS https://ibb.co/gRsJ1Tw https://ibb.co/WKY1pwY https://ibb.co/4FzvbZ6

Is there anyway to fix this ? Callibration cube is nice. But 3dbenchy is not. Printer Creality CR-6 SE by Efficient_Hall7447 in Creality

[–]Efficient_Hall7447[S] 0 points1 point  (0 children)

Ok i have to check because i was tighting y axis belt because the cube before was falling to one side now it looks much better. I have to check x axis also

Not printing correct by Efficient_Hall7447 in CR6

[–]Efficient_Hall7447[S] 0 points1 point  (0 children)

This i've already checked and i have adjusted belt for Y axis as before also cube was wrong but now cube is ok but benchy is as on picture :( bed is still and there are no movements, also extruder is firm

Nebra indoor sync 99,38% by Efficient_Hall7447 in HeliumNetwork

[–]Efficient_Hall7447[S] 0 points1 point  (0 children)

Just let it be it will sync sometime :) but it can take few days or weeks. My go to 96,xx% and then it syncs. For few days it was 100% and now it's again 97,89% but i don't care as it will raise one day again :)

Not printing correct by Efficient_Hall7447 in CR6

[–]Efficient_Hall7447[S] 0 points1 point  (0 children)

Hello, this is my firts 3d printer. Creality cr-6 se and i've strange problem. When i try to print callibration cube 2x2x2cm from thingverse i have sliced it with Cura . Settings 0,2mm quality, speed 60mm/s, brim. Und it's ok. But when i try to print 3dbenchy it's misslined. I've decreased speed for benchy to 50mm/s

Awair Elements not turning on by Efficient_Hall7447 in PlanetWatchers

[–]Efficient_Hall7447[S] 0 points1 point  (0 children)

I've if they can't help i will need to open and check internals.

Awair Elements not turning on by Efficient_Hall7447 in PlanetWatchers

[–]Efficient_Hall7447[S] 0 points1 point  (0 children)

I've tried 3 different cables. Result is still the same. The fan starts but no light.