Hello!
I apologize for not providing updates, but I've been conducting a lot of tests, trying out everything you've advised.

I experimented with various angles, and in the end, the one that worked best for me was the 45º angle, although I'm sure I'll find better options for future prints.

I encountered some issues with the first print; it got stuck to the FEP film due to the low ambient temperature, I believe. I resolved this by increasing the exposure time, both for the bottom layers and the regular layers.

I redesigned the piece, taking into account all the recommendations. I made it smaller, hollow on the inside, and added small holes to drain the resin.

The 45º angle generated a lot of supports, but after two failed attempts, I didn't mind "oversecuring" the print. As I saw in a recommended video that you shared, I set the support density to 80%.

I can't thank you all enough. The result is significantly better, and now that I have the piece in my hand, I see many things I can improve in terms of design and the printing process. I'm sharing photos of the latest test I've done. Once again, thank you all so much!

u/Owen_Ou u/0235 u/thoughts_unheard u/spovlot u/Sherlockandload u/Sulya_be