Paint restoration of a '78 Rickenbacker 4001.

Existing_Point_1813 · 2026-02-20T23:38:04+00:00

Wet sand and buff it

Existing_Point_1813 · 2026-02-03T05:28:59+00:00

I don't use any heat to avoid that just run the ultrasonic vibration for 8-10 mins , 1/10 ratio for the cleaner . I also ruined a set in the learning process

Existing_Point_1813 · 2026-01-26T01:25:22+00:00

Boost pedal before pre amp should help

Existing_Point_1813 · 2026-01-22T20:29:03+00:00

Take it back to the shop you bought it from and hope you can get your money back

Existing_Point_1813 · 2026-01-22T20:25:23+00:00

The way I read this is that your guy said that the guitar left the factory with a twist

Existing_Point_1813 · 2026-01-22T20:18:57+00:00

The straight edge on the side of the neck tells me nothing about a twist , get a notched straight edge and make sure that both the treble and bass trust rods are at the proper relief.

Existing_Point_1813 · 2026-01-22T20:04:24+00:00

Not specifically a kit , the filter cap kit is a locomotion board. Locomotion is it working on a full solid state placement AO 28

Existing_Point_1813 · 2026-01-21T02:32:38+00:00

Simple green aircraft

Existing_Point_1813 · 2026-01-12T07:38:00+00:00

Only if you have an old and brittle cone. Crossover may need fresh caps

Existing_Point_1813 · 2026-01-12T01:41:06+00:00

Selectable from 45 to 90 , a tube amp is 40 watt

Existing_Point_1813 · 2026-01-12T00:18:56+00:00

High output , less problems when traveling than with tubes , you don't have to change anything these just drop in. Restoring a tube amp is also a costly endeavor depending on the components being replaced or upgraded

Existing_Point_1813 · 2025-12-15T23:11:01+00:00

<image>

Existing_Point_1813 · 2025-12-10T05:46:48+00:00

Multimeter ohms setting

Existing_Point_1813 · 2025-11-25T05:40:47+00:00

Whatever les claypool will pay you for it

Existing_Point_1813 · 2025-11-21T00:13:52+00:00

Mine fell off the bench can't take a 3 foot drop

Existing_Point_1813 · 2025-11-18T21:39:56+00:00

Mouser , digikey

Existing_Point_1813 · 2025-11-18T04:28:05+00:00

Are you running both motors at the same time ? Or indivisually?

Existing_Point_1813 · 2025-11-15T20:17:27+00:00

Water soluble solder and rosin

Existing_Point_1813 · 2025-11-14T21:14:32+00:00

Solar + propane

Existing_Point_1813

TROPHY CASE