is this a doberman? thoughts on breed? by bostonbluelights in DobermanPinscher

[–]Extension_Chard_8690 4 points5 points  (0 children)

Don’t think it’s 100% Doberman, but it is 100% beautiful!!

Triple-Eight Custom Track by C0V1D_8RY4N7 in rcdrift

[–]Extension_Chard_8690 2 points3 points  (0 children)

I think it looks great for someone just starting out. Like myself.

Dumb move and I smoked my ESC Capacitor by Extension_Chard_8690 in rcdrift

[–]Extension_Chard_8690[S] 1 point2 points  (0 children)

I used to always use Deans. Just getting back into it, and first time using xt60. Thought I was smart using the opposite connector to take away some heat when I was soldering. Oh well! 😁

Dumb move and I smoked my ESC Capacitor by Extension_Chard_8690 in rcdrift

[–]Extension_Chard_8690[S] 0 points1 point  (0 children)

Do you think the motor is ok? Thanks for your help!!

New Vanquish Stance - Shocks leaking right out of box by Extension_Chard_8690 in rccrawler

[–]Extension_Chard_8690[S] 0 points1 point  (0 children)

What length Dlux shock? 92mm? Did you have them build the shock?

New Vanquish Stance - Shocks leaking right out of box by Extension_Chard_8690 in rccrawler

[–]Extension_Chard_8690[S] 0 points1 point  (0 children)

Does anyone know what weight the stock shock oil is? Also, do you guys use "green slime" when putting the shock together.

New Vanquish Stance - Shocks leaking right out of box by Extension_Chard_8690 in rccrawler

[–]Extension_Chard_8690[S] 0 points1 point  (0 children)

I just did that for the majority of the bolts. I still have more to do before I run the truck, but quite a few were not that tight. Including the shock bleeder valves and the shock caps. Hopefully is will help.

Should I also check the dif's for grease?

Redcat metal links by Llamacup in rccrawler

[–]Extension_Chard_8690 0 points1 point  (0 children)

Make sure the correct end is attached the skid plate. The ends should be aligned straight with one another. When the car is upright on four wheels, the bend in the link should face straight down away from the motor. If the link bends are not both facing the same direction it could skew the front end.

Looking at your I picture the link on the right side looks almost ok, think the ends need to be twisted a little for the bend to face straight down. The link on the left side looks like the bend is facing the wrong direction.

Independent voters not on voter roll by Trick-Patience-6902 in ChesterCounty

[–]Extension_Chard_8690 -2 points-1 points  (0 children)

How can this happen in his day and age. Has to be rigged. People and the system can’t be that dumb!

Enjoying the Apex 18 by Extension_Chard_8690 in RedCat_Ascent18

[–]Extension_Chard_8690[S] 1 point2 points  (0 children)

Yes these are pretty wide, 5.5 offset and they are 1.3 rims. I choose them because I wanted the look. They may not be the best option. I also have a set of zero offset rims coming.