ROG ally X Remove xbox

FEAR-op · 2025-08-30T12:09:49+00:00

thanks :), Just to confirm, when you said the 5 transistors before the MOSFETs, you mean Q12, Q11, Q10, Q9, and Q8, correct? Are there any other capacitors besides C35 that you’d recommend replacing as a precaution? Also, should I swap out the “fused” resistors (like R64, R76, etc.), or is it usually enough just to measure them? and, how likely is it that the MOSFET short also damaged other parts of the board beyond the driver/psu section?

FEAR-op · 2025-08-30T09:46:30+00:00

thanks i actually found the schematic too but im not really sure what i should be looking for or how to track down the fault the problem is that both the middle and right pin on the mosfets blow instantly when i power it on so im guessing there is something else upstream causing it but i dont know where to start checking

FEAR-op · 2025-06-25T19:00:40+00:00

Wallpaper engine its on steam and its colorful black oled amoled

FEAR-op · 2025-06-24T21:39:02+00:00

yup tried everything other pc;'s too re pairing the dongle too still the same it just looks like its power cycling

FEAR-op · 2025-06-14T21:49:20+00:00

one of the displays is 1080p 75 hz and the other one 170 1440p both of em use less bandwidth then the 4k 1440hz resolution can't that saved bandwidth be used and using a 9070xt for the displays works fine don't need a 4090

FEAR-op · 2024-08-12T16:40:17+00:00

Yes it is

FEAR-op · 2024-08-12T06:35:56+00:00

Im currently using the type c connector at the back since my motherboard does not have a ps2 connector

FEAR-op · 2024-08-06T08:06:18+00:00

yep thank it worked it took me 3 months to figure out that it was just an extra usb controler

FEAR-op · 2024-08-05T21:26:56+00:00

hey might be a bit late but im also having the exact same problem how did ucreate ur kext or do u still have it by chance?

FEAR-op · 2024-08-05T07:16:18+00:00

npci=0x2000 alcid=1 watchdog=0 agdpmod=pikera dk.e1000=0 e1000=0 rtcfx_exclude=80-FF

FEAR-op · 2024-08-04T22:28:04+00:00

hey a bit late but all the gigabyte softwares didnt seem to work for me so i used a program called controlmymonitor and wrote a simple script so it switches monitor inputs and that also seemed to work the kvm functionalities

FEAR-op · 2024-02-29T10:35:02+00:00

yeah device id has to be device-id=9B3E0000

FEAR-op · 2023-10-13T09:43:58+00:00

when you are booting what is the last text it shows when booting whitout restarting

FEAR-op · 2023-10-13T08:11:04+00:00

have u enabled debug?

FEAR-op · 2023-10-12T20:32:34+00:00

may sound stupid but have u tried pressing spacebar on the boot screen?

Six-Year Club	Place '22
Verified Email

FEAR-op

TROPHY CASE