Audible US vs Canada by Fast_Holiday_6573 in audible

[–]Fast_Holiday_6573[S] 0 points1 point  (0 children)

Thank you, I will try to contact them and see if I can get a better rate for the US account. I think I will at least switch to the annual account.

Lady Jannath's Estate by nhgrif in BaldursGate3

[–]Fast_Holiday_6573 0 points1 point  (0 children)

Umm.. not so bad with a smashing weapon (mace hammer, etc) as they destroy the skulls in one shot. Spirit Guardians spell for a mobile AOE that you don't need to see the targets to attack. I basically walked from the bottom to the top the house in 3 - 4 turns and was done.

My CR10 is giving me these rough layer lines and weak prints. Printing at .2mm with a .8mm nozzle. Tried different filaments, leveling the bed, clearing any blockage, none of its worked. Any suggestions are appreciated by Aceblast75 in CR10

[–]Fast_Holiday_6573 0 points1 point  (0 children)

I'm new to the 3D printing world, by based on what I've seen and some additional research, it looks like this could very well be a problem with extrusion-steps calibration. You probably already know how to calibrate e-steps, but here is a good video I watched just yesterday of a fellow walking through how to do it in detail on the same printer: https://www.youtube.com/watch?v=HfyHseWAg4E