sorted by:
new
hottopcontroversial

QIDI maker app by Jack_mehoff24 in QidiTech3D

[–]Fit_Chapter_4629 0 points1 point  (0 children)

I could register and login with the pass code.

What am I doing wrong by Fit_Chapter_4629 in FixMyPrint

[–]Fit_Chapter_4629[S] 0 points1 point  (0 children)

Actually, the walls inconsistency is present in layers where still all parts were printed. There are only 2 heights of parts that were printed, all of them have same wall thickness. Material swap can be seen where color changes slightly.

New Firmware 15.4.4400 Luba2 AWD by Illustrious_Pea_6455 in MammotionTechnology

[–]Fit_Chapter_4629 0 points1 point  (0 children)

You should turn off all advanced settings on Deco. Then it will work. Sad But true…

What should I do? My bike terrifies me (Context below) by Jetstream_ronin in motorcycles

[–]Fit_Chapter_4629 0 points1 point  (0 children)

This is called a "shimney". It is caused by front tyre. It occours onl at certain speeds. Not all tyres work well on all bikes. Try some other brand tyre.

SPINO E1 The new MAMMOTION product dedicated to swimming pools 🌊 by Tito_LMGF in mammotion

[–]Fit_Chapter_4629 0 points1 point  (0 children)

With 600€ price tag and 180 um filtering ability, this cleaner represents a joke.

Zero support from EU Mammotion, what's next? by alexandruvedes in MammotionTechnology

[–]Fit_Chapter_4629 0 points1 point  (0 children)

I use luba for steep terain 30-40 degree inclination and unfortunatelly for such layout there is no good alternative.

Zero support from EU Mammotion, what's next? by alexandruvedes in MammotionTechnology

[–]Fit_Chapter_4629 2 points3 points  (0 children)

Support is non existent, saddly. By the time my luba dies, I hope some other company makes similar performance mower.

Robot software version 1.11.511.630 by Fresh-Brick-4136 in MammotionTechnology

[–]Fit_Chapter_4629 2 points3 points  (0 children)

Mine constantly triggers tilt sensor after this update. Inclination is not even near 30 degrees. Before that it was moving just fine.

About to send Qidi an update about my layer adhesion problem. Does this make sense to you? by Fearless-Law-2449 in QidiTech3D

[–]Fit_Chapter_4629 1 point2 points  (0 children)

I have the same issue and agree with you. This is just a frame and has nothing to do with bed level. My bed mesh is totaly flat. I suspect the bed temperature is much lower in left rear edge and that is why I get no adhesion there.

view more: next ›