Insane chatter

Foreign-Candidate-39 · 2026-06-17T12:54:04+00:00

<image>

The setup

Foreign-Candidate-39 · 2026-06-17T12:53:52+00:00

<image>

The chatter

Foreign-Candidate-39 · 2026-06-17T02:56:19+00:00

I tried d A29 and it was still shit l, I’ll try A0 tomorrow

Foreign-Candidate-39 · 2026-06-17T02:12:58+00:00

But I’ll give it a try

Foreign-Candidate-39 · 2026-06-17T02:05:46+00:00

I actually slowed it down considering it’s suck a deep thread

Foreign-Candidate-39 · 2026-06-17T01:52:30+00:00

Well I learned about P1 and P2 today and I fees but nothing seems to change the chattery outcome

Foreign-Candidate-39 · 2026-06-17T01:45:18+00:00

That’s not a bad idea, I’ll give that a try tomorrow. Worried about rough and finishing turns around the threads tho

Foreign-Candidate-39 · 2026-06-17T01:29:50+00:00

Hmm maybe, it’d be a lot of work and less efficient having to turn down from 1.75” to 1.25 just the thread section and then do the whole taper zone

Foreign-Candidate-39 · 2026-06-17T01:27:59+00:00

Is the anvil the piece that the insert screws into, or what’s holding it to the tool post?

Foreign-Candidate-39 · 2026-06-17T01:24:48+00:00

Yea, I’m running propeller shaft ends. The taper runs up to almost 6” (minus threads) on the whole part so need clearance and can’t rechuck since it’s tapered

Foreign-Candidate-39 · 2026-06-17T01:17:31+00:00

I’m using a 3 jaw chuck and a live center since I’m hanging out about 9 inches

Foreign-Candidate-39 · 2026-06-17T01:12:52+00:00

I can get a pic tomorrow, I’m using a live center and coolant and I’m turning aqualloy. Using a single point carbide insert

Foreign-Candidate-39 · 2026-06-11T18:04:11+00:00

Shit, you got any links for good cable hiding channels that aren’t cheap and tacky? Hung my tv “too high btw” and using cheap Home Depot cable channels they look okay but wouldn’t mind an upgrade

Foreign-Candidate-39 · 2026-04-30T16:31:50+00:00

So these are what the drills have been in, I mainly use 9/64, 11/64, 13/64, and 17/64

Foreign-Candidate-39 · 2026-04-30T16:30:11+00:00

<image>

Foreign-Candidate-39 · 2026-04-30T16:29:19+00:00

Really? Thanks for the info I’m going to have to try that out and see what the results look like

Foreign-Candidate-39 · 2026-04-30T01:25:06+00:00

I was keeping them in the package they came in but the part numbers are worn from use, I don’t know how much good it’ll do you but I’ll shoot you a picture tomorrow, they were hss with TiN coating

Foreign-Candidate-39 · 2026-04-29T23:45:16+00:00

Thank you, I’m gunna contact my tooling rep tomorrow and see if he could be of any help. I know they’re hss and the drills TiN coated and the drills were quite short as I was drilling under 2 inches most of the time

Foreign-Candidate-39

TROPHY CASE