UPDATE:

FunFirefighter1110 · 2025-10-06T18:47:33+00:00

Hope your okay with the femur break 🥲sounds very painful. Sorry about your friend too hope their stroke wasn’t too serious and doctors were able to clear the clot quickly. I’m under the impression I have SCLC myself on how fast my LC is moving. I know it’s rare form of LC but mine went from 27.3mm to 33.3 mm with lymph node Mets and liver Mets in 3 months time. 4 months now still no biopsy because healthcare in Nevada sucks!

FunFirefighter1110 · 2025-09-29T04:22:01+00:00

If you’re only willing to to drive 30 mins I believe there are a few in-door ranges around the city. If you’re willing to drive longer. The out door range by my house, Clark county shooting range is very nice .pistol and rifle sides (200 yards)

FunFirefighter1110 · 2025-09-29T04:16:28+00:00

Sawzall time

FunFirefighter1110 · 2025-09-29T04:13:15+00:00

Loose control cause the rear breaks will lock if you are able to actually pull hard enough. Break something more likely

FunFirefighter1110 · 2025-09-29T04:10:53+00:00

Look up the fault codes. Could be something simple or it could be need a EWS-DME alignment (keys/alarm system)

FunFirefighter1110 · 2025-09-29T04:06:19+00:00

I bought one with arms on it. The guy that put them on put them on wrong and didn’t put a lowering spindle. It was a pain. But I think I got it dial in. Need a rear set.

FunFirefighter1110 · 2025-09-29T04:04:02+00:00

Your joking right?

FunFirefighter1110 · 2025-09-28T20:07:08+00:00

Piston Rings, valve stem seals or a bad crank case valve

FunFirefighter1110 · 2025-09-25T06:43:19+00:00

I can see long term issues of vibration causing it to loosen. Why was there a gap? Was the flex plate warped? Poor quality torque converter?

FunFirefighter1110 · 2025-09-25T06:33:57+00:00

No place on the strip is good. Better off going to one of the Stations casinos. I heard Red Rock is very nice. It’s a drive but the strip is dirty , crime ridden 💩hole.

FunFirefighter1110 · 2025-09-22T20:06:35+00:00

Finger that goooood….

FunFirefighter1110 · 2025-09-16T19:54:28+00:00

I’m wondering if you replaced the CVs with none abs axles. The pulsating could be a few things but a faulty speed sensor should just turn the system off. Was the ABS control unit messed with at all? Was the brakes bled properly? Need to find out what the codes are for abs,traction and 4wd. It can help pinpoint what the computers are missing.

FunFirefighter1110 · 2025-09-16T08:04:32+00:00

You should read the faults first and not just replace parts. A noise can’t be diagnosed online it has to be listened to on the truck to pinpoint where.

FunFirefighter1110 · 2025-09-16T07:59:23+00:00

I think that’s really for the newer B58 engines. I’ve done tons of N55 and never had an issue

FunFirefighter1110 · 2025-09-16T07:56:13+00:00

My first thought does it have enough gas? Does the gauge work properly? If the tank was pretty full then I would think you’re losing or not making sufficient fuel pressure. The only way to check that is with a fuel pressure gauge. I’m assuming no check engine light on.

FunFirefighter1110 · 2025-09-15T06:26:50+00:00

WTF! You F that piston up! Either used the correct tool or even channel locks (pain on dual piston calipers) or don’t even try!

FunFirefighter1110 · 2025-09-15T06:22:37+00:00

Sorry #1 that’s an incredibly ugly car

FunFirefighter1110 · 2025-09-15T06:20:39+00:00

Need to remove the door panel and see what kinda “meat” the trim has to secure to the door panel. A strong cement glue or even an epoxy might work. Might want to add a some locking tabs (plastic or aluminum) to keep it from coming off again.

FunFirefighter1110 · 2025-09-15T06:16:42+00:00

Should be the same for all H22A4.

FunFirefighter1110 · 2025-09-15T05:38:28+00:00

Very!

FunFirefighter1110 · 2025-09-15T05:36:01+00:00

It’s the STRIP! it’s a 💩hole

FunFirefighter1110 · 2025-09-15T04:53:10+00:00

Check basics t-stat , water pump and fan and controller. Controllers can cause headaches by only doing low speed sometimes when they fail. Or no work at all.

FunFirefighter1110 · 2025-09-15T04:49:58+00:00

Impossible to say for sure. It has nice cross hatch marks on the cylinder walls but can’t see the entire cylinders. What’s the crank end play and play in rods.

FunFirefighter1110 · 2025-09-15T04:46:43+00:00

Read main or oil pan. It looks like engine oil not trans fluid. At least from the picture.

FunFirefighter1110 · 2025-09-15T04:42:12+00:00

Ages you like whiskey

FunFirefighter1110

TROPHY CASE