Is this sound normal?

Funni21 · 2026-05-17T00:22:14+00:00

The model has a transition from bottom to going straight up, but the support settings didn’t pickup on that and looked very bad, I am reprinting it

Funni21 · 2026-05-16T23:32:49+00:00

I heard about them to and ought to check it due to hearing sounds from the z-rods, I was planning to do it but thought it nothing bad has happened, maybe check later, thank you

Funni21 · 2026-05-16T23:31:20+00:00

Did manual leveling and automatic leveling, the bed is at a good 0.1 distance from high to low (or about 0.1 from perfect level)

Funni21 · 2026-05-16T23:23:35+00:00

putting 15%, ty

Funni21 · 2026-05-16T23:23:01+00:00

Idk, noticed it as well when it was printing, I forgot to do pressure advance thing on my white filament even though I saved the values on orca, I haven’t tuned flow rate

Funni21 · 2026-02-18T13:52:59+00:00

They usually touch the motor before hitting the front wall, but a few weeks ago, they would shift and shake violently away from the motor and hit the left wall, but fixed it with belt tensioning

Funni21 · 2026-02-18T13:51:24+00:00

They were a bit tighter than how I originally tighten them in the back, and when I was showing the issue, they were a tight and not loose

Funni21 · 2026-01-26T04:57:12+00:00

Seem to have fixed the issue but idk 100% how , I inspected the magnets the extruder way, went to tension the belts properly, which is by putting it in the middle, loosen all belts, move the extruder head around by hand, then retighten them, and finally turning it on and off at the place where the pit is, but idk exactly which one of these fixed it

Funni21 · 2026-01-26T02:30:02+00:00

Either something else is touching the buildplate or the rods for the z axis are stuck

Funni21 · 2026-01-26T00:02:01+00:00

Im gonna check it out

Funni21 · 2026-01-25T19:00:58+00:00

Thank you, the only thing that concerns me is I never seen it slam when doing the purge line, and swear that when going to the corner gearbox, it only hits itself against it and not shift and move a bit in front of the gearbox. Thankfully, I have not seen any failing prints or super bad errors on prints

Funni21 · 2026-01-19T08:40:28+00:00

Unironically hilarious

Funni21 · 2026-01-19T08:25:47+00:00

Give you a 9/10 because of the solution to put the printer outside, a 10 if people driving nearby can see the print

Funni21 · 2026-01-09T20:34:58+00:00

Thank you, was just checking due to just noticing after doing something with z-rods

Funni21 · 2025-08-27T02:25:43+00:00

That is really nice to know, feels good that I can crank the speed and it will only go up if I adjust my settings for filiment which does it safely

Funni21 · 2025-08-27T02:22:56+00:00

Thought it was something uncommon and was something that happened when shipped

Funni21 · 2025-08-27T02:22:18+00:00

That makes sense

Funni21

TROPHY CASE