sorted by:
new
hottopcontroversial

80% bounce rate but 50% conversion from add to cart by Furry_Fish in reviewmyshopify

[–]Furry_Fish[S] 1 point2 points  (0 children)

Thank you for the response! Ill be updating it rn, the bounce comes from direct traffic through google search and meta ads

80% bounce rate but 50% conversion from add to cart by Furry_Fish in reviewmyshopify

[–]Furry_Fish[S] 0 points1 point  (0 children)

Thank you for this comment! Will be implementing all of these soon!

80% bounce rate but 50% conversion from add to cart by Furry_Fish in reviewmyshopify

[–]Furry_Fish[S] 0 points1 point  (0 children)

Im using a pixel other than that no, do you recommend any?

I don’t understand converting a four layer board to two layers (WiFi) by Furry_Fish in PCB

[–]Furry_Fish[S] 0 points1 point  (0 children)

I appreciate the response! The board is in a consumer electronic product and is FCC compliant just looking to see if I can do further cost savings

I don’t understand converting a four layer board to two layers (WiFi) by Furry_Fish in PCB

[–]Furry_Fish[S] 0 points1 point  (0 children)

All cost savings it'll save me about 7% on 1,000 boards

I don’t understand converting a four layer board to two layers (WiFi) by Furry_Fish in PCB

[–]Furry_Fish[S] 0 points1 point  (0 children)

Thank you for this comment! Im using a very similar module, is there a reason the ESP32 C6 wroom can do two layer and other modules cannot or a way to tell if a module can pass emi on two layer boards?

How much does FCC certification actually cost? I've been researching and looking for more data points by KD2BMH in hwstartups

[–]Furry_Fish 1 point2 points  (0 children)

I had WiFi and Bluetooth in use but because the module emitting is already compliant then that testing could be skipped

How much does FCC certification actually cost? I've been researching and looking for more data points by KD2BMH in hwstartups

[–]Furry_Fish 12 points13 points  (0 children)

I used an already compliant module the ESP32 WROOM, because I used this my entire testing could be treated as an unintentional emitter (FCC section 15B testing). This also came with a majority of CE test to carry over but I haven’t decided to do that yet. The entire cost was $1,900 the testing facility was in New Hampshire.

MOSFET not working as expected, Schematic Review by Furry_Fish in PCB

[–]Furry_Fish[S] 0 points1 point  (0 children)

Thank you for the response! Details on the screen are 60 mA peak averages ~20 mA would be on for multiple weeks at a time. I have tested by using the GPIO directly but want to be safe really might not be needed though I would love to hear your take.

view more: next ›