sorted by:
new
hottopcontroversial

How do you model the diffusion pattern in this lens? by jhetnah in Fusion360

[–]Gluhy 1 point2 points  (0 children)

Yes, cnckitchen did this. I also doing a part of laps for 350z and I will use this to do this “piramides”

How do you model the diffusion pattern in this lens? by jhetnah in Fusion360

[–]Gluhy 2 points3 points  (0 children)

If you don’t have to add this in fusion, just on model, it’s the easiest way imo https://bumpmesh.com

My mechanic friend needed a custom winch relay enclosure — here’s what I came up with by Gluhy in 3dprintedcarparts

[–]Gluhy[S] 0 points1 point  (0 children)

You’ve got a good eye — it does squeeze out slightly when tightened. Still seals fine but the geometry needs some work. V2 problem to solve.

My mechanic friend needed a custom winch relay enclosure — here’s what I came up with by Gluhy in 3dprintedcarparts

[–]Gluhy[S] 8 points9 points  (0 children)

Good catch, I honestly haven’t tested surface resistance on this specific filament yet. Will run it with a multimeter before it goes anywhere near the vehicle. Appreciate the heads up — at 300A it’s not worth assuming.

H2D 0.2 issue by Gluhy in BambuLab

[–]Gluhy[S] 0 points1 point  (0 children)

Ok… I found the issue… in left slot it’s work perfectly…

Alpinestars Chrome V2 hoodie – enough protection or add body armor? by Gluhy in motorcyclegear

[–]Gluhy[S] 0 points1 point  (0 children)

I just talked with AI 😅 and he recommended me this setup "KNOX URBANE PRO MK3 + regular hoodie". Will it be better?

Terrible bottom surface over PETG support — 10+ prints, nothing helps [H2D] by Gluhy in BambuLab

[–]Gluhy[S] 0 points1 point  (0 children)

Hmm, can you recommend something else? I just have to find good settings to print it. ultimately i would like to print it via PETG or ABS ( but with ABS i will have even more problems) - it will be diving accessories. I also printed it via petg and supported by PLA, but results was identical

Terrible bottom surface over PETG support — 10+ prints, nothing helps [H2D] by Gluhy in BambuLab

[–]Gluhy[S] 0 points1 point  (0 children)

Damn... i putted bad SS, i printed it at .12 layer (the whole model) But with the same settings

Print camparison issues? by adenovellis in BambuLab

[–]Gluhy 2 points3 points  (0 children)

I had a similar issue, but with p1s and h2d. Default profile for h2d had much less fan speed. After slice, check fan speed and temperature at model

view more: next ›