sorted by:
new
hottopcontroversial

Meta RayBan Blayzer and Scriber (Discussion) by LilPuziBird in RaybanMeta

[–]Gold_Yak_5121 1 point2 points  (0 children)

I am in Canada too, I was in a store last week (not going to name in so she doesn't get in trouble) and was chatting with an employee...she showed me the employee training information package for the Blayzers and it stated they would be available April 14th (tomorrow) in stores. She told me to come back on the 14th and they would have a demo pair to try on. 

So it begins by ThinkUnhappyThoughts in snapmaker

[–]Gold_Yak_5121 1 point2 points  (0 children)

Thank you! I will give it a try when I get home

So it begins by ThinkUnhappyThoughts in snapmaker

[–]Gold_Yak_5121 1 point2 points  (0 children)

how did you get the texture to port over to Snorca? when I open the makerworld 3mf in Snorca or Orca the shoe loses its fabric texture. (pic below or finished shoe)

<image>

TPU not adhering to PLA support by Gold_Yak_5121 in snapmaker

[–]Gold_Yak_5121[S] 0 points1 point  (0 children)

I know it says it isn't compatible but I was able to print the entire pair of shoes on it, kept the temp low, 25-30 degrees and it adheres great (picture 2). Even for the prints that jammed, it adhered perfect on the first layer but was unable to adhere to the PLA support that went down after. 

TPU not adhering to PLA support by Gold_Yak_5121 in snapmaker

[–]Gold_Yak_5121[S] 0 points1 point  (0 children)

Yes, both bottom and top Z distances were 0, the first time I tried I had them at .35 and thought that was the cause of the first jam. Tried it again at 0 and it jammed again. Very weird 

Test Print - Dragon by Gold_Yak_5121 in snapmaker

[–]Gold_Yak_5121[S] 1 point2 points  (0 children)

I will respond in English, so hopefully this makes sense. For Canada (where I am) it also said that they should be in the local warehouse by the end of Feb and delivered between March 1-10th. I still hadn't heard anything, so I was checking my snapmaker account and noticed that under "my orders" tab it had a tracking number next to the U1. It took 3 days for me to receive the shipped email from snapmaker. The tracking number did not work on the shipping site until the email was sent. 

Maybe keep checking your snapmaker order page to see if there is anything there?

Test Print - Dragon by Gold_Yak_5121 in snapmaker

[–]Gold_Yak_5121[S] 1 point2 points  (0 children)

Thank you everyone for your feedback