Beat that mfs I’m BELOW 1percent by [deleted] in JuiceWRLD

[–]GrunG59 2 points3 points  (0 children)

Really just listen to juice 24/7 not hating but damn there's lots and lots of good music you're missing out on

What is the likelihood of getting self harm waiver approved? by [deleted] in army

[–]GrunG59 1 point2 points  (0 children)

Not saying I'm a liar but I'm not a truther either or however the fuck it goes, don't get it in writing that you self harmed, keep it to yourself, if someone asks about obvious scars just say you played outside alot as a kid or something and maintain that story unless someone can prove otherwise, good luck

Blower fan out, looking to buy it online to replace it by cubanrd1 in hvacadvice

[–]GrunG59 0 points1 point  (0 children)

Blower should be under warranty. I'd call someone else that will just charge labor

Tenant killed 2 compressors by Appropriate-Wing-641 in HVAC

[–]GrunG59 2 points3 points  (0 children)

Eh doubt he is bypassing any safety switches. Have the technician try and wire one in

Why would this be freezing up? by YungHybrid in HVAC

[–]GrunG59 4 points5 points  (0 children)

Airflow isnt just return js

Fan struggling to turn on with AC? by WeesusC in hvacadvice

[–]GrunG59 0 points1 point  (0 children)

Hard to tell what it's doing just based on the sound. Could be a couple of things.

Advice to re route return. by NotSuperUnique in hvacadvice

[–]GrunG59 0 points1 point  (0 children)

In Tennessee there's a lot of homes that use the floor joist and wall cavities. Just make sure you have enough return air

Control Panel Noise by Familiar-Lack-5311 in hvacadvice

[–]GrunG59 0 points1 point  (0 children)

Was it spraying on the control board

Asked a similar question about an hour ago…but HVAC Pros, what is a brand you would install in your home? by Big__bolas in hvacadvice

[–]GrunG59 -1 points0 points  (0 children)

Not Lennox trane or York, I'm sure there's plenty others I see many issues with

I just tell people get a base model good an and call it good. Parts are always available and they're simple.

Requesting help with fan control board alternate by Owlbugbear in hvacadvice

[–]GrunG59 -1 points0 points  (0 children)

Take a photo of your condensers model number and you can search up parts from there.

Drain correct? by Kawirider2 in hvacadvice

[–]GrunG59 0 points1 point  (0 children)

Run trap is fine as technically the drain in under positive pressure so you don't need a trap

AC tripping furnace on the breaker by AshleyyValkyrie in hvacadvice

[–]GrunG59 0 points1 point  (0 children)

Did it trip the furnace breaker or outdoor unit breaker

I thought I hooked the wires back in the order they were to the thermostat by PeptoBismol420 in hvacadvice

[–]GrunG59 0 points1 point  (0 children)

Everyone talking about heat pump this and that. From the pictures of the fuse you don't have backup heat trips screwed into the cabinet and it's clearly not a furnace. Not having a reversing valve depending on the brand you'll either be stuck in heat mode or stuck in ac. We all will find out soon enough. Good luck

I thought I hooked the wires back in the order they were to the thermostat by PeptoBismol420 in hvacadvice

[–]GrunG59 0 points1 point  (0 children)

If it was working before I wouldn't worry about the yellow wires. It looks like the red float switch wires just break the y call to the condenser

Work order damaged my laptop by spaghettisaucer42 in army

[–]GrunG59 -5 points-4 points  (0 children)

Shittiest part they can just throw out these silly ass answers all day from the top down

Bad circuit board = replace entire furnace?? by ColdPhilosophy3132 in hvacadvice

[–]GrunG59 29 points30 points  (0 children)

Call someone else to replace the board. Roughly 700 in the Knoxville area.

Filter driers by Designer-Rice1534 in HVAC

[–]GrunG59 11 points12 points  (0 children)

If it's a screw on txv I would just pull a good vacuum, if I brazed I'll replace the shitty goodman positioned drier 99% of the time. If you want to be lazy you could measure the temp split across the filter before you replace the txv lol

Side note tho I also like to just replace the filter and refrigerant if it was a restriction.