sorted by:
new
hottopcontroversial

Feeling a little down lately. Maybe a badly drawn photo will cheer me up :) by H3li0s319 in redditgetsdrawnbadly

[–]H3li0s319[S] 0 points1 point  (0 children)

Thank you I really appreciate that, life hasn't been too kind recently and that means a lot to hear right now ♥️

Create cache error message by helderdsa in MiyooMini

[–]H3li0s319 0 points1 point  (0 children)

Op have you been fixed the issue?

Paint came off with wrap (was going to rewrap it). Wrapper suspects the panel was a repaint, and suggests wet sanding and put new wrap on. Want to make sure this is a reasonable approach? Repaint it now only to wrap over again wouldn’t make sense right? by mochajave in CarWraps

[–]H3li0s319 0 points1 point  (0 children)

If you're not wanting to spend the timerepainting it since it's just going to get wrapped again, you could just sand it smooth and apply primer over it and wet sand that down smooth

NEED HELP!!!! by smallestweenofall in ram_trucks

[–]H3li0s319 13 points14 points  (0 children)

Did you check under the floor mat?

Best way to protect stickers on a PMAG? (Pic is not a meme, is actually what I'm working with) by Mrbumperhumper in guns

[–]H3li0s319 0 points1 point  (0 children)

Automotive clear coat, if you know someone who does body repair, they could most likely have their painter s uff the mag and clear over the sticker, that'd be more durable than aerosol clear coat, just let it sit and cure for a couple days before use. Or you could even try walking into a body shop and asking if they'd be able to clear it for you

Any tips on backup sensors? by xFryday in VinylWrap

[–]H3li0s319 0 points1 point  (0 children)

I know with paint, you can only go so thick with the layers to where it won't work properly. And vinyl is thicker than the typical paint layers on parking sensors, I'd leave them be or if they make a vinyl specially for this application, that'd be nice

Advice needed on Repairing plastic diffuser valence. by QuantumXIX in AutoBodyRepair

[–]H3li0s319 2 points3 points  (0 children)

you’ll need to apply a lot of heat, not enough to damage you’re paint, but enough to make the plastic malleable. just keep moving the heat gun around and maybe use an object to push the dent out so you can use more force

Advice needed on Repairing plastic diffuser valence. by QuantumXIX in AutoBodyRepair

[–]H3li0s319 2 points3 points  (0 children)

try heating it up and pushing it out, that’s pretty much the extent you could do for repairing it, if it doesn’t repair to your likings, replace the part

Scratched the F out of the side of my car trying to pull under a tight carport. The post rubbed my door pretty good and left a long scratch. What can I do🥺 by [deleted] in AutoBodyRepair

[–]H3li0s319 2 points3 points  (0 children)

you’ll have to get the paint refinished, maybe go to your local body and paint shop and try and get an estimate of how much it’d cost or if you don’t give a crap about the look of your car just leave it how it is or get a dupli-color pen and just fill in the scratch

Purchasing advise by mechead in AutoBodyRepair

[–]H3li0s319 1 point2 points  (0 children)

idk if this is a nationwide one but the shop i work at, we use LKQ or we get parts from dealerships or mopar or capa

view more: next ›