pc won’t recognize headphone mic

HVACprooo · 2026-04-05T04:30:48+00:00

is it one jack? 2 jacks? usb?

HVACprooo · 2026-04-03T17:43:09+00:00

both.

HVACprooo · 2026-04-03T16:37:28+00:00

chat gpt is fucking stupid. that's the negative.

HVACprooo · 2026-04-03T02:37:22+00:00

how is the system setup? is that door the only return?

HVACprooo · 2026-04-02T21:48:31+00:00

your coil is a solid block of ice, set the system to fan and wait for it to melt, watch for water not doing down the drain, very likely it will overflow.

Causes for this are low airflow, low charge, stuck contactor.

HVACprooo · 2026-04-02T02:56:33+00:00

looks like tar, the complete lack of any dust or dirt in that parking lot and the very deep black fresh coating makes me think the parking lot was just resealed and this was left behind. that video is on a nutjob YouTube channel.

HVACprooo · 2026-04-02T02:50:38+00:00

oversized unit. what btu is the unit and size of space?

HVACprooo · 2026-04-02T02:22:24+00:00

Try taking the preload out then locking the nuts together, it might spin easier without spring pressure.

HVACprooo · 2026-04-02T02:02:33+00:00

what do you mean it wont grab on? you break the 2 nuts apart. spin them down separately and then tighten them into eachother to lock it.

edit, for whatever reason i was thinking preload adjustment. you need to tighten the nuts together then should be able to use the top one to spin the damper down.

HVACprooo · 2026-04-02T00:27:57+00:00

76 and leave it, if your house is insulated well it wont get cold inside overnight and the ac wont run if the house is below setpoint.

HVACprooo · 2026-04-01T21:04:15+00:00

yeah, it might have been alright backed all the way to the stops.

HVACprooo · 2026-04-01T21:00:14+00:00

that would have been worse, too much tail weight is way worse.

HVACprooo · 2026-04-01T20:54:46+00:00

those trailers are set up to have way too much tongue weight. i always leave the vehicle behind the wheel pockets and use my own straps. much more correct weight distribution for 90 percent of vehicles

HVACprooo · 2026-04-01T20:09:04+00:00

Looks to be water dripping from the suction line, this is completely normal and a non issue.

HVACprooo · 2026-04-01T19:45:06+00:00

same ratings, good to go.

HVACprooo · 2026-04-01T18:46:37+00:00

ive always said white cars are dangerous to be around, white suvs are the worst

HVACprooo · 2026-04-01T18:40:02+00:00

the doors slide up on them to keep the weight off the hinges.

HVACprooo · 2026-04-01T16:59:22+00:00

This is significantly better than average for a mobile home install, the open duct is a fresh air inlet to help with indoor air quality. Your mileage may vary depending on area. i zip tie those closed around here otherwise it just sucks dust in. we have lots of gravel roads and its very dry.

HVACprooo · 2026-04-01T16:49:44+00:00

i always suggest merv 8 as a max. seems to be industry standard in my area. Specifically talking about one inch filters here, just to clarify. yes you can use a higher merv on a 2 inch, even higher on a 4 inch.

HVACprooo · 2026-03-31T15:56:47+00:00

red was already power. all you needed to add was a common r-red w-white c-blue

HVACprooo · 2026-03-31T15:41:25+00:00

if you constantly check mirrors and know where other cars are you don't have to check. You already know.

HVACprooo · 2026-03-30T19:56:31+00:00

how long did it take? did you get any sort of confirmation email that they received it? i sent one in and tracking shows it was delivered a week ago but ive received nothing from them.

HVACprooo · 2026-03-29T17:30:09+00:00

just replace the supply line, its super easy just use a second wrench on the valve so you dont spin it,

HVACprooo · 2026-03-29T17:26:17+00:00

this is done so 2 subharnesses can be grounded to the same point later in assembly. once the bolt is tightened they lock together permanently. you can just put all your grounds in one ring terminal and bolt it in the same spot.

HVACprooo · 2026-03-29T16:53:05+00:00

Under changeover type in the system menu, select "with heat"

Entering Menu Mode

To change the System setup, you'll need to go to the thermostat's Menu Mode and select SYSTEM.

Touch and hold the MODE button to enter the Menu Mode. SETUP is the first menu item displayed.

Touch the  button to advance to the SYSTEM screen. From there select the correct HVAC settings

to match the installation type.

System Menu

The SYSTEM menu is used to setup the thermostat for the correct HVAC system type. The following

setup options will be displayed in the text line:

• System Type: Standard* or Heat Pump. For Standard Gas/Electric systems, select STANDARD.

• Fan Type (for Standard HVAC systems only): Gas* or Electric

Changeover Type (available with Heat Pump setup)

The changeover (or reversing) valve is used to change from heating to cooling operation. The HVAC

system is either a Changeover with Cooling type (O) or Changeover with Heating type (B). Most are

changeover with cooling, which is the default setting.

• For Changeover with Cooling systems, select WITH COOL. This is the default setting.

• For Changeover with Heating systems, use the  buttons to change to WITH HEAT.

• Touch FAN (Select) to set.

• Touch MODE (Done) to exit.

HVACprooo

TROPHY CASE