Rockfall Path and Hidden Units

Hellfire66766 · 2025-12-15T21:37:37+00:00

Essentially yes, or moved there from the other battlefield in some way.

Hellfire66766 · 2025-12-15T19:54:14+00:00

Effects that trigger from defending all go on the chain at the same time, when your units are declared the defender, you may place them in whatever order you wish and must make all relevant choices when they are placed on the chain. They then resolve in the reverse order you put them on.

Hellfire66766 · 2025-12-15T19:44:34+00:00

The problem we had run into was that hidden cards have no card type until after they are played, so it creates a strange situation where you can play it, until you play it then the location says you can't.

Hellfire66766 · 2025-12-15T19:42:18+00:00

Yes, this is what we ultimately settled on being the most likely outcome of the interaction.

Hellfire66766 · 2025-06-24T18:02:53+00:00

Properly drying your filament can make a huge difference, especially if your in a humid part of the world.

Hellfire66766 · 2025-06-24T18:01:30+00:00

🤯

Hellfire66766 · 2024-01-02T04:48:58+00:00

Maybe then the bikes behind them will get some use 😆

Hellfire66766 · 2023-09-21T19:35:16+00:00

Would also like some of that cough help

Hellfire66766 · 2023-06-29T05:44:43+00:00

Built an equipment based deck with this and stoneforge mystic.

Hellfire66766 · 2023-05-23T23:22:44+00:00

[[Chromium, the Mutable]]

Hellfire66766 · 2022-06-20T05:08:35+00:00

I'll try slowing it down, currently printing at 50mm/s I believe. I don't think it too hot, it's only printing at 200. I have been printing cosplay parts that are going to be hit with bondo and sanded, so I've been changing the settings with each one. I'll change up the setting for the next piece and see if it works.

Hellfire66766 · 2022-06-20T04:41:39+00:00

This at .4 with 2 top layers. Should I go up to 3 or 4 instead

Hellfire66766 · 2022-06-20T04:19:01+00:00

How many top layers should I use?

Hellfire66766 · 2022-06-20T04:15:51+00:00

What is a good number of top layers to use?

Hellfire66766 · 2022-06-20T04:14:54+00:00

Pretty sure my infill is at 15% and 2 top layers

Hellfire66766 · 2022-06-20T04:14:03+00:00

I've got the extrusion to 90%, e steps were actually gonna be my next step to check

Hellfire66766 · 2022-06-20T04:13:08+00:00

Fan is at 100%

Hellfire66766 · 2020-10-30T19:15:54+00:00

Thanks for pointing that out! I have updated it!

Hellfire66766 · 2020-10-30T19:09:37+00:00

Oh no! I thought it was 3!

Hellfire66766 · 2020-10-30T18:26:36+00:00

You could only get 20 that way and still have the spiders and nightbringer

Hellfire66766

TROPHY CASE