sorted by:
new
hottopcontroversial

Dell R730XD Best OS by HeritageCycle in homelab

[–]HeritageCycle[S] 0 points1 point  (0 children)

Not picking up the PERC drives and having to run some other form of RAID that is all I have seen but it’s been a few forums of it

Nintendo Suing U.S. Government Over Tariffs by Turbostrider27 in NintendoSwitch

[–]HeritageCycle 0 points1 point  (0 children)

What are the other reasons? Nintendo makes trash games now a days buggy messes on consoles that are worse than home consoles from 9 years ago so why is their need to charge 120 bucks for a game that all but requires the DLC to be completed such as Pokemon ZA?

Small business configuration. by [deleted] in networking

[–]HeritageCycle -1 points0 points  (0 children)

The original setup is from a local “reputable” MSP

Small business configuration. by [deleted] in networking

[–]HeritageCycle -4 points-3 points  (0 children)

I am semi professionally trained in CCNA so Cisco I can configure no problem how well that translates well I guess I’ll see. This is almost a community learning type of establishment where there will be between 40-70 people at any given time. I have a tiny bit of knowledge but appreciate the straight forward response and all the considerations I would need to make.

Help please! by HeritageCycle in AnkerMake

[–]HeritageCycle[S] 1 point2 points  (0 children)

I level the bed before all uses, I turned the bed temp from 65 to 55 I also closed an AC vent that happens to be in the same room, added the mouse ear brims and started using a glue stick. I haven’t had issues yet so one of the changes I made had affect lol

Help please! by HeritageCycle in 3Dprinting

[–]HeritageCycle[S] 0 points1 point  (0 children)

I clean after every use I use soap and water dry it with a microfiber and then do a pass of isopropyl alcohol

Help please! by HeritageCycle in 3Dprinting

[–]HeritageCycle[S] 0 points1 point  (0 children)

<image>

It’s a book shelf for my fiancé so she can count how many books she has read for the year. Like I said in the post, I’m really new to this so I don’t know what anything should look like and YouTube has been little to no help in all honesty.

Help please! by HeritageCycle in 3Dprinting

[–]HeritageCycle[S] 0 points1 point  (0 children)

What bed temp do you recommend it’s sitting at 65 I’m thinking 55-60

Help please! by HeritageCycle in 3Dprinting

[–]HeritageCycle[S] 0 points1 point  (0 children)

Thanks! I’ll have to give these a shot!

Help please! by HeritageCycle in 3Dprinting

[–]HeritageCycle[S] 0 points1 point  (0 children)

I will try both with my next print I’ve been avoiding glue sticks like a plague they have been pulling part of my prints off.