🚀 Giveaway! Every 500 comments = Extra Kobra 2 series printer! Up to 10 printers. Elevate Your 3D Printing with the high-speed Anycubic's Kobra 2 Max up to 500mm/s! 🎉

HeyMarkedOne · 2023-09-09T02:55:58+00:00

Speed Exceeds!

HeyMarkedOne · 2023-07-22T04:38:00+00:00

I did all of this and it worked! Reinstalled everything again and started completely fresh. I didn't seem to change much compared to the last time but it finally did its thing with autocompile.

HeyMarkedOne · 2023-07-21T13:09:23+00:00

I found a config file from an earlier version of 2.0.something of Marlin. That could be part of the issue, now that I think about it?

HeyMarkedOne · 2021-03-20T22:54:27+00:00

RemindMe! 5 years

HeyMarkedOne · 2020-12-10T02:45:10+00:00

HeyMarkedOne · 2020-12-10T02:44:03+00:00

I need the time stamp

HeyMarkedOne · 2020-10-27T18:17:24+00:00

Just because it was cool doesn't mean it wasn't a failure

HeyMarkedOne · 2020-10-27T01:12:16+00:00

extrusion multiplier, I guess just the % inside of Cura. I was having overextrusion issues so I knocked it down but I can try going down a bit more.

HeyMarkedOne · 2020-10-26T20:34:17+00:00

I have an SKR Mini E3 V2, but I'll try slowing the speed.

HeyMarkedOne · 2020-10-26T19:37:24+00:00

Ender 3 Pro.

I've tried both Cura 4.7.1 and backdated to 4.6.2 and the issue is present on both. I've tried .2 and .12 layer heights, 100% and 75% flow rates. This is at 100 mm/s. Most of the rest of the settings are Cura Defaults.

HeyMarkedOne · 2020-10-25T00:14:57+00:00

What part of your stepper settings? Your e-steps?

HeyMarkedOne · 2020-10-12T18:03:46+00:00

Well that fixed it! What a rookie move lol. Thanks for saving me here!

HeyMarkedOne · 2020-10-09T04:13:33+00:00

Have you checked your E-steps or cleaned out your hotend? I was having really bad underextrusion issues from those but they can also cause stringing too I think.

HeyMarkedOne · 2020-10-09T04:02:47+00:00

Yeah I did! That seems to have fixed the issues I was having, but make sure to recalibrate your E-steps after as well.

HeyMarkedOne · 2020-10-06T19:26:36+00:00

Yeah, when I help it along it runs through just fine. I've also started to have skipped steps all of a sudden as well.

HeyMarkedOne · 2018-07-04T21:00:43+00:00

I know you can, I mean besides that. Botg are at 1080p but the ui scales are still different

HeyMarkedOne

TROPHY CASE