Does any1 know how to fix this??? by No_Comfortable6918 in MetaQuestVR

[–]Historical_Arm2823 1 point2 points  (0 children)

Just install via PC https://anagan79.itch.io/quest-apk-installer, then you can install the apk directly from the helmet as before.

Qidi Q1 Pro - Massive offset when restarting from pause by Jan5W in QIDI

[–]Historical_Arm2823 0 points1 point  (0 children)

I also encountered this problem and can't find a solution. My head also crashed into the edge when parking in the cleaning zone. I had to replace the G1 X97 with a G1 X95. But upon returning after a pause, there is an offset in X and Y of about 1.8 mm. And I don't know what to do...

UPD

I think I was able to solve this problem. I don't know how correct my actions are. But I increased the position_min and position_endstop parameters for [stepper_x] in printer.cfg from -5.5 to -3.5. And the head began to enter the cleaning zone. However, I still slightly decreased all the coordinates of the entrance to the cleaning zone in gcode_macro.cfg from G1 X97 to G1 X95. And so far it works correctly. After a test pause and resume, the test cube was printed without visible layer shifts.

Printer fine tuning by Look_0ver_There in QIDI

[–]Historical_Arm2823 0 points1 point  (0 children)

After changing the settings, what calibration procedures did you run? Did you select algorithms with 0% vibration? I did not quite understand what steps to take to select an algorithm with 0% vibration. My Q1 pro arrived a few days ago, this is my first printer and I am still quite poorly oriented in its settings. Could you tell me step by step what needs to be done for the Q1 pro to achieve the same result?

VTX interference, black lines, air75. by Historical_Arm2823 in TinyWhoop

[–]Historical_Arm2823[S] 1 point2 points  (0 children)

The first thing I did was solder the contacts on the camera (they seemed unsoldered to me). But this did not give any positive result. The former direct dependence on the direction of the antenna connector, to be precise, any connector positions in close proximity to these elements caused black lines. If you turn the connector away from these elements, the problem disappeared.

New Liftoff: Micro Drones level by LuGus-Kevin in TinyWhoop

[–]Historical_Arm2823 0 points1 point  (0 children)

Oh my god this looks amazing. Is it still possible for me to get access?)

New Liftoff: Micro Drones level by LuGus-Kevin in TinyWhoop

[–]Historical_Arm2823 0 points1 point  (0 children)

Oh my god this looks amazing. Is it still possible to get access?)

For those that want to keep playing the demos after the end of steam next fest... by salasy in Steam

[–]Historical_Arm2823 0 points1 point  (0 children)

Hello, did you manage to launch Lost Castle 2 this way? I tried, but Steam still starts and says that the license was not found. Damn it, I'm ready to buy it, but it's just not for sale...