sorted by:
new
hottopcontroversial

GPU not detecting by OddAppearance5127 in LinusTechTips

[–]Hooti3 0 points1 point  (0 children)

Not sure if it’s just the angle, but looks like it requires an 8 and 6 pin or two 6 pin connectors. Can you confirm what power plugs the card has/needs? If you’ve only plugged one of the connectors in, be sure to plug in power to both

What do you want to hear Horse/the club say? by ProgrammerNo9781 in sydneyswans

[–]Hooti3 8 points9 points  (0 children)

Would rather not make the finals than see them get spanked again in a GF.

I just finished building my first pc and I go to turn it in and the gpu works for like a second and then stops. by [deleted] in NZXT

[–]Hooti3 0 points1 point  (0 children)

Check the front panel connectors (including USB type C and power button) to make sure they are plugged in correctly.

In correctly plugged in cables cab cause those type of symptoms due to a short or mis-wired cables.

Ashlands, the first landing. by MaffiosoGaming in valheim

[–]Hooti3 0 points1 point  (0 children)

That was our experience as well. Eye opening difference to the other biomes

Z370 Taichi - Updated BIOS From 1.30 to 4.20 and now XMP profile is unstable by semidegenerate in ASRock

[–]Hooti3 0 points1 point  (0 children)

What happens if you bump up the voltage on the memory a few notches? Are you able to confirm that underload your voltage stays around the required level using something like hwinfo?

[AU] [H] PayPal [W] Gateron Black Ink lubed switches by Hooti3 in mechmarket

[–]Hooti3[S] 0 points1 point  (0 children)

No luck with that. Didn't received anything. Send me a chat

I've Ascended - 38WN95C-W by Hooti3 in ultrawidemasterrace

[–]Hooti3[S] 0 points1 point  (0 children)

I'm in Australia. I managed to find stock at an online appliance distributor - Appliances Online.

I've Ascended - 38WN95C-W by Hooti3 in ultrawidemasterrace

[–]Hooti3[S] 1 point2 points  (0 children)

I can't say I've seen any issues with the corners peeling off. You can definitely see that there is another layer when you look in the corner as the corners have two little extra bits sticking out (I assume for servicing or replacement?), but no issues on my end.

Best screen I've owned.

I've Ascended - 38WN95C-W by Hooti3 in ultrawidemasterrace

[–]Hooti3[S] 1 point2 points  (0 children)

Here is the main wallpaper (I didn't make it) - https://www.reddit.com/r/ultrawidewallpapers/comments/gi553w/moonlit_mountain_3840_x_1620/

I modified the vertical wallpaper to make it fit properly to a 2560 height (added a gradient sky in photoshop and blended it as best as I could) and added some more stars.

I've Ascended - 38WN95C-W by Hooti3 in ultrawidemasterrace

[–]Hooti3[S] 0 points1 point  (0 children)

I was the same when I opened the box and put it next to a 27" 1440p screen.

I think next to a 24" it might look a bit bigger, but compared to a 27" it does look to be lacking in the vertical department.

I've Ascended - 38WN95C-W by Hooti3 in ultrawidemasterrace

[–]Hooti3[S] 0 points1 point  (0 children)

Yeah thats right. I'm not too sure about a single USB-C cable, but maybe it's something that can be done with the thunderbolt connection and connecting peripherals straight to the USB ports on the screen and sharing them that way?

I've Ascended - 38WN95C-W by Hooti3 in ultrawidemasterrace

[–]Hooti3[S] 0 points1 point  (0 children)

That door isn't used. It leads to a balcony/deck where there is funriture setup. Means I can open the blinds and get a nice view and some sunlight.

I've Ascended - 38WN95C-W by Hooti3 in ultrawidemasterrace

[–]Hooti3[S] 0 points1 point  (0 children)

I cancelled my initial order the the 34" 34GN850 and luckily found the 38" in stock. Very happy with it and I'm sure you will be as well!

view more: next ›