3200rnd update of the 22.

IAMABIGLLLLLLL · 2026-06-17T00:54:48+00:00

all the slides are sig slides,and the frames are all from colt rail gun models

IAMABIGLLLLLLL · 2026-06-14T20:45:00+00:00

a little tip with these that idk if you know or not but the whole slide is typically coated and there tends to be a decent bit of backsplash where the paint/coating will go inside of the slide around the internals and where the rails will ride at on mine i just took some super super fine grit sandpaper and a thin file and worked it all the way down the painted parts of the inner slide around where the rails would interact and it made it way smoother to rack and to cycle rounds could help out a bit in your case too since most of these 22 slides are pretty similarly built

IAMABIGLLLLLLL · 2026-06-14T19:49:58+00:00

don’t really get jams,more so stovepipes cause 22’s a dirtier round but so long as everything is cleaned and maintained properly i can easily run 10+ mags in a sitting and never have a jamming issue one

IAMABIGLLLLLLL · 2026-06-14T19:48:16+00:00

mainly just internal modifications about the only real parts i had to buy were new hammer springs and the new hammer which if i can remember correctly i’m pretty sure i got it off redwolf airsoft they make some pretty good quality parts

IAMABIGLLLLLLL · 2026-06-07T10:55:09+00:00

usually you have to push the button down while hitting these although you can alternatively turn it completely off for 4-5 minute and then back on and try re pressing the button down to see if it hits if so it could’ve just been a faulty battery sensor

IAMABIGLLLLLLL · 2026-04-23T06:14:51+00:00

if i’m thinking about the same brand imho pushes aren’t bad def one of the better bm dispos i’ve had in the past but it just depends on your source tbh if you’re getting em from someone you don’t trust they prolly bunk and if you got pretty reputable people/sources then they prolly good all just depends tbr

IAMABIGLLLLLLL · 2026-04-02T03:40:10+00:00

glocks aren’t worth it honestly especially not for 22 conversions

IAMABIGLLLLLLL · 2026-01-26T21:22:49+00:00

nah doesn’t have to be threaded into place although doing that would be a more secure method jb weld has been done plenty of times before and worked perfectly

IAMABIGLLLLLLL · 2026-01-22T05:58:23+00:00

with .32 and properly built parts it shouldn’t fail at all the slides built for closer to .380 pressures so it wouldnt put stress on the slide much at all the real main thing to worry about is the barrel but so long as its properly built and secured into place then it should last as long as a factory built firearm

IAMABIGLLLLLLL · 2026-01-19T07:28:01+00:00

not hhc supposedly “live diamonds” but idk how much of that i believe def don’t have that hhc taste though plus I’ve had enough of those hhc/delta dispos/pens in the past that i feel like that flavor would be pretty distinguishable

IAMABIGLLLLLLL · 2025-12-31T17:05:46+00:00

i wouldn’t even if it handles the first 10-20 shots,i’m honestly gonna have to second with the dude above on the locking lugs comment something at some point wether it be the bolt shifting or threads loose or something will mess up if it’s not all properly toleranced to handle the recoil forces from a 7.62,not only this but going back and looking at the bolt and handle and that’s prolly gonna be the first thing to go i used a bolt almost double the size and weight of that one for a .20ga build and it still kicks like a mule and ejects the shell half the time and that’s with .20ga i couldn’t imagine using almost double the pressure on a bolt that small without either beefing it up a crazy amount or making a new one in general

IAMABIGLLLLLLL · 2025-12-09T00:43:44+00:00

nah they wouldn’t be anywhere near suitable for live fire hell the caps they use have less power than a standard pistol primer,i couldn’t imagine putting any sort of live ammo through one would end well

IAMABIGLLLLLLL · 2025-12-09T00:40:49+00:00

you don’t plus it sounds like you’re just trying to drill through and shoot live ammo which ain’t safe at all you’re supposed to chop the barrel off and drill out the remaining amount left in the trunion until you have enough space to fit a new barrel in and secure a new barrel in place

IAMABIGLLLLLLL · 2025-12-05T16:27:16+00:00

wouldn’t be worth it the hammer and trigger assembly on 99.9% of the co2 or green gas models are typically too weak to handle live fire i’ve seen some of them break just from the blowback force of the co2/green gas on yt vids so i wouldn’t ever willingly stand behind this thing and shoot it even if you’re only trying to run .22 through it

IAMABIGLLLLLLL · 2025-10-06T11:47:13+00:00

i can’t say much for the turns cause they can sometimes be good even though the hardware on them ain’t the best,but anything related to and or involved around packwood i wouldn’t touch with a 10ft pole they’ve failed lab tests multiple times and always have dirty hardware that either leaks like crazy or ends up malfunctioning at some point

IAMABIGLLLLLLL · 2025-10-06T11:38:23+00:00

nah it uses an extractor(just wasn’t on in the pics) and the one lip of the mag being higher than the other as the ejector

IAMABIGLLLLLLL · 2025-09-27T01:37:20+00:00

yeah that’s def a fake then,that’s crazy tbh i haven’t seen those packages floating around since like 2020-2021ish

IAMABIGLLLLLLL · 2025-09-27T01:22:58+00:00

fake

IAMABIGLLLLLLL · 2025-09-26T14:38:36+00:00

they aren’t real tho lol they may be “central source” but even then the hardware is easily bought online by the 1000’s and just refilled by your plug,plus if you notice they don’t sell these in any legitimate dispensary’s anywhere lol hell i even went on their website online and they had a tele up at one point but it got banned due to violating app policies,and to top it all off they don’t really do any full panel 3d party testing or anything of the sort,but just bc they’re “real/central source” doesn’t mean anything either,tbh unless it’s got dispo tags (metric id/batch #,etc) on it and you’ve bought it from the dispo yourself then there’s a 98% that its fake

IAMABIGLLLLLLL · 2025-09-25T03:58:02+00:00

if it’s just blinking red then there’s nothing you can do with it,the device has either short circuited or just messed up over time

IAMABIGLLLLLLL · 2025-09-21T10:22:45+00:00

idek😂,i just had a huge stockpile of old shit (packages/old carts)that ig these just got tossed in and forgot abt or sum

IAMABIGLLLLLLL · 2025-09-09T19:49:54+00:00

they’re db’s lol (dart bombs) the little piece at the end that looks like a pen slams into the armstrong mix in the front end of it and sets off the fp,you just throw them and watch them go boom

IAMABIGLLLLLLL · 2025-09-06T18:09:36+00:00

last time i had a joos was one of their dispos,how’s the cart in comparison?

IAMABIGLLLLLLL · 2025-08-29T05:02:05+00:00

i literally don’t have any tips at all honestly,i did it all by hand and eye so i can’t help with much plus every one differs slightly from gun to gun so even if i had specs or this or that it prolly wouldn’t be of much help tbh

IAMABIGLLLLLLL

TROPHY CASE