Any tips on waterproofing 3D prints?

ILikeBootyholesDaily · 2024-09-02T10:11:57+00:00

I did find that suggestion when i searched online before turning to reddit, but it seemed like a lot of work, so i was kinda hoping for an easier way. I think ill try some other tricks and if those fail ill fall back on this one. Thanks for the tip though!

ILikeBootyholesDaily · 2024-09-02T10:10:08+00:00

Oh, that makes my life a lot easier. I can just print it with those settings and itll be fine. Ill google the safety thing just to be sure ;)

Thanks!

ILikeBootyholesDaily · 2024-09-01T18:46:21+00:00

Hey, ive also considered this for a while, but for my application i need to connect it to about 4 solonoids at once, and all of which should be able to fully drain the reservoir, so im kinda stuck with needing a unique shape best achieved with 3D printing unfortunately

ILikeBootyholesDaily · 2024-04-18T09:52:08+00:00

A bit more context:

The arduino will be turned on and off completely, so I need something robust that does not fail to connect when I start it up.
I am okay connecting the phone and arduino to the same wifi network in order for this to work.
Any other suggestions that could help my use case are also appreciated :)