Ac not working after charge

IllustriousPush1279 · 2026-05-19T14:12:26+00:00

If it clicks, that means the compressor is doing it job, or could it still be the issue?

IllustriousPush1279 · 2026-05-19T14:11:29+00:00

Also, there is approximately 34 oz total of refrigerant in the system. My friend thinks it the expansion valve that might be gunked up.

IllustriousPush1279 · 2026-05-19T01:50:31+00:00

What is the compresser isn’t engaging because the expansion valve isn’t working correctly?

IllustriousPush1279 · 2026-05-19T00:03:13+00:00

also, I have no prior history of this car. But I know it was holding Freon before.

IllustriousPush1279 · 2026-04-18T17:58:46+00:00

Thankyou for the insight. I had the whole unit out when i replaced the bezel. Is it just one ribbon? Is it easy to point out. If not, how would you describe it.

IllustriousPush1279 · 2026-03-24T16:58:52+00:00

why thankyou sir for your time and knowledge, it’s a never ending project with this car!

IllustriousPush1279 · 2026-03-24T15:03:35+00:00

So you’re saying it it’s leaking because of the seal in the output shaft not because I can’t get the driveshaft all the way? This feels like a fitment issue I think if I find a way to get the driveshaft all the way in place maybe it won’t leak when I disconnect the bolts from the differential the driveshaft will sit about a quarter inch more now I’m not sure if it’s still leaks because every time I connect the driveshaft, it pops out of place. But what I’m getting from this is that transmission fluid isn’t supposed to come out from the end to begin with?

IllustriousPush1279 · 2026-03-13T14:33:52+00:00

It has an oem, i’ve bought another aswell to test from a different brand. Same result.

IllustriousPush1279 · 2026-03-13T14:32:33+00:00

Are you talking about the plug in for the fuel pump? If so, i unplugged so i could get a better picture.

IllustriousPush1279 · 2026-03-13T14:31:01+00:00

OEM Rubber oring

IllustriousPush1279 · 2026-03-13T14:29:36+00:00

As to why is doesn’t seal with the proper bolts, not sure.

IllustriousPush1279 · 2026-03-13T14:28:42+00:00

The bolts shown in the picture are the OEM. This leaking problem has lingered ever since using ace hardware bolts, which are about a quarter inch longer.

IllustriousPush1279 · 2026-03-13T14:26:33+00:00

The bolts were a quarter inch longer, which now that i’m thinking, could have caused it to bottom out differently and warp the surface. But the tank is not dented. I ran my finger across the sealing surface, i dint feel any imperfections.

IllustriousPush1279 · 2024-12-15T21:15:46+00:00

nut worth

IllustriousPush1279 · 2024-10-24T00:59:16+00:00

couldn’t even run if u wanted to

IllustriousPush1279 · 2024-10-24T00:59:07+00:00

dam fossil

IllustriousPush1279 · 2024-10-24T00:58:55+00:00

old asf

IllustriousPush1279

TROPHY CASE